Search:

Type: Posts; User: TBAx

Page 1 of 17 1 2 3 4

Search: Search took 0.04 seconds.

  1. When you want to swap the rain sensor module with...

    When you want to swap the rain sensor module with another with index B, then this should not cause any problems or issues.
  2. Replies
    2
    Views
    112

    Setting the lower voltage limit or the...

    Setting the lower voltage limit or the temperature limits should work like in other MQB-alike cars.
  3. Thanks for your offer, which I will kindly deny,...

    Thanks for your offer, which I will kindly deny, as I don‘t think my post is worth 25$. ;)
  4. You mean something like this? ...

    You mean something like this?


    https://www.youtube.com/watch?v=RA3c8vD_3bc

    From your AdpMap in this thread I would suggest the following changes in the BCM adaptions:

    Allow comfort opening...
  5. Hi, I guess you mean this BCM adaption...

    Hi,

    I guess you mean this BCM adaption channel:
    "Access control 2-Freigabenachlauf FH bei Tueroeffnen abbrechen" (Disallow operation of automatic windows after door opening)

    Set it to "not...
  6. Yes, it does. Parking lights (position lights...

    Yes, it does. Parking lights (position lights active without ignition) will run for as long as possible until the BEM (battery energy management) in the Gateway sends notice that the battery is at...
  7. Replies
    8
    Views
    147

    In module 20 (which is basically the Light Assist...

    In module 20 (which is basically the Light Assist module) there should be adaption channel #1 and #2 which allows setting the "Low Beam Speed Threshold" and "High Beam Speed Threshold".
    Check the...
  8. Replies
    1
    Views
    85

    I don't think so. However 20% doesn't make much...

    I don't think so. However 20% doesn't make much of a difference so it should work like before.
  9. Replies
    8
    Views
    147

    Okay, got it. I am pretty sure you can remove the...

    Okay, got it. I am pretty sure you can remove the „Light Assist“. Could you post an Auto-Scan for better understanding of what control modules are in your car?
  10. Replies
    8
    Views
    147

    I'm puzzled. Are you asking to disable the...

    I'm puzzled. Are you asking to disable the automatic low beam/drl toggle while still having the same automatic in place?
    Or, as another question, where's the difference between "main beam" and "full...
  11. Thread: Audi green screen

    by TBAx
    Replies
    21
    Views
    819

    Check your PMs :)

    Check your PMs :)
  12. Thread: Audi green screen

    by TBAx
    Replies
    21
    Views
    819

    Yes, it should still work. Has the part number...

    Yes, it should still work. Has the part number changed in the CarPlay activation process? Or asked in another way: the SW part number is still "4G1 035 025 E"?
  13. Thread: Audi green screen

    by TBAx
    Replies
    21
    Views
    819

    Normally it should not. I got this once, after...

    Normally it should not. I got this once, after the dealer installed an firmware update to the main unit. Other than that (and obviously a swap of the unit) I do not see a reason for this to happen.
  14. Yep, that‘s normal. Reset the Lighting to factory...

    Yep, that‘s normal. Reset the Lighting to factory settings in the HMI to push the change to the active settings.

    Same thing happened in older cars like the Golf MK6. Reason is an overlay of...
  15. Replies
    14
    Views
    422

    Raising the value above 100% heightens the...

    Raising the value above 100% heightens the displayed/calculated consumption. So if the car uses more fuel than displayed in the DIS/HMI and you want to fix that, that is the way to go. Likewise a...
  16. Replies
    4
    Views
    131

    Not possible on a Leopard 2A5. ;) On MQB cars...

    Not possible on a Leopard 2A5. ;)
    On MQB cars it‘s possible.
  17. Replies
    6
    Views
    207

    Does the station in question support the display...

    Does the station in question support the display of current song via RDS?
  18. Replies
    2
    Views
    202

    To my understanding Byte 18 and all of it’s magic...

    To my understanding Byte 18 and all of it’s magic still applies to your car. However I would not recommend to fiddle with it, as hard-to-fix problems could appear.

    Instead you better find someone...
  19. Replies
    11
    Views
    404

    What modell and year is your car?

    What modell and year is your car?
  20. Replies
    24
    Views
    794

    There is no difference. I guess it was just the...

    There is no difference. I guess it was just the missing action to disable the checkbox in the MMI/HMI.
  21. Thread: Audi green screen

    by TBAx
    Replies
    21
    Views
    819

    Check your Private Messages for a possible fix...

    Check your Private Messages for a possible fix for the Security Access.
  22. Replies
    24
    Views
    794

    The MIB is the multimedia interface in the middle...

    The MIB is the multimedia interface in the middle of the dashboard.

    After changing the adaption channel you can switch DRL using the MIB/HMI going into Menu > Car > Setup > Lights > Daytime...
  23. Replies
    17
    Views
    4,131

    FCWP is definitely Forward Collision Warning...

    FCWP is definitely Forward Collision Warning Pedestrian.

    I just randomly guess the FCWO might be Forward Collision Warning Other.
  24. Thread: Audi green screen

    by TBAx
    Replies
    21
    Views
    819

    Please post an Auto-Scan for further reference.

    Please post an Auto-Scan for further reference.
  25. Thread: Audi green screen

    by TBAx
    Replies
    21
    Views
    819

    Did you use the special SA (in VCDS) / switch to...

    Did you use the special SA (in VCDS) / switch to Engineer session (in ODIS) before changing the adaption?
Results 1 to 25 of 420
Page 1 of 17 1 2 3 4