Search:

Type: Posts; User: Uwe

Page 1 of 20 1 2 3 4

Search: Search took 0.58 seconds; generated 23 minute(s) ago.

  1. Thread: ECU potential bad

    by Uwe
    Replies
    1
    Views
    15

    I guess the first thing I would do is to pull the...

    I guess the first thing I would do is to pull the connector(s) from ECU and check the condition of the pins. There should be no water in there, and no corrosion.

    -Uwe-
  2. Thread: If I dig a hole

    by Uwe
    Replies
    7
    Views
    55

    Maybe one like this? ...

    Maybe one like this?
    ...
  3. Thread: Mk4 Immo2 issues

    by Uwe
    Replies
    7
    Views
    75

    Those old immo clusters would always allow the...

    Those old immo clusters would always allow the engine to start during the ignition cycle in which you did a valid Immo login.

    In order to test whether keys have been adapted successfully, you must...
  4. Thread: If I dig a hole

    by Uwe
    Replies
    7
    Views
    55

    Almost swimming distance to the beaches south of...

    Almost swimming distance to the beaches south of Cádiz... :thumbs:

    -Uwe-
  5. Not just VCDS. The Gateway also reports several...

    Not just VCDS. The Gateway also reports several with the status: "Cannot be reached".

    The ignition appears to be on; if it wasn't, VCDS would report a low voltage on the Vign pin of the DLC.
    ...
  6. Replies
    1
    Views
    13

    The old Login function simply doesn't exist on...

    The old Login function simply doesn't exist on modules that use the UDS protocol, which your ECU does.

    You should probably tell the BCM that there's a CCS installed too (Byte 17).

    Then check...
  7. If it runs well with the MAF unplugged, then I...

    If it runs well with the MAF unplugged, then I think you can be reasonably confident that either the MAF is bad or there's a wiring/connector issue with it.

    Have you tried logging the MAF? It...
  8. Source of replacement MAF? Have you verified...

    Source of replacement MAF?

    Have you verified all wiring and connectors relevant to the MAF?

    -Uwe-
  9. Thread: If I dig a hole

    by Uwe
    Replies
    7
    Views
    55

    In the Southern Ocean, close to Antarctica? ...

    In the Southern Ocean, close to Antarctica? Make sure it's a covered boat, not an open one.

    -Uwe-
  10. Replies
    6
    Views
    73

    Well the makers of the product are telling you it...

    Well the makers of the product are telling you it isn't.

    -Uwe-
  11. Replies
    6
    Views
    73

    Getting help in this forum requires the use of a...

    Getting help in this forum requires the use of a legitimate VCDS system.

    They are available directly from us:
    https://store.ross-tech.com/shop/cat/VCDS

    ... Or from any of our authorized...
  12. Replies
    10
    Views
    250

    There is "Deviation from Nominal Vehicle Height"...

    There is "Deviation from Nominal Vehicle Height" in MVB 004 and "Absolute Vehicle Height" in MVB 005, but these don't correspond to the directly to measurement between the axle centerline and the to...
  13. Thread: Battery

    by Uwe
    Replies
    31
    Views
    1,291

    12.9V is not horrible. It's enough to keep the...

    12.9V is not horrible. It's enough to keep the battery from discharging, but it sure isn't going to put a full charge into it either.

    -Uwe-
  14. Merged this new post back into your original...

    Merged this new post back into your original thread regarding the same transmission.

    What was the source of the replacement parts that you installed?

    -Uwe-
  15. Replies
    1
    Views
    47

    Since this question doesn't appear to involve...

    Since this question doesn't appear to involve VCDS in any way, moving to General VW/Audi Repair.

    -Uwe-
  16. Thread: How to check boost

    by Uwe
    Replies
    3
    Views
    74

    Please post an Auto-Scan...

    Please post an Auto-Scan so we can see what you've got.

    -Uwe-
  17. Replies
    5
    Views
    112

    I rather doubt it. They hide all that stuff in...

    I rather doubt it. They hide all that stuff in their own scan tool these days and the values they have even in that will usually be just the ones that are relevant to a particular fault that they...
  18. Can you please repeat the scan using...

    Can you please repeat the scan using "Auto-Detect" rather than "XX - All Addresses", (should only take ~5 minutes rather than 30-some), or even just post a Gateway Installation List, so we can see...
  19. Thread: Battery

    by Uwe
    Replies
    31
    Views
    1,291

    Right, when you are decelerating or braking,...

    Right, when you are decelerating or braking, there is free energy available and they try to use this to keep the battery charged rather than using a tiny bit more fuel to do so the rest of the time. ...
  20. Thread: How to check boost

    by Uwe
    Replies
    3
    Views
    74

    Why are you using software that's almost two...

    Why are you using software that's almost two years out-of-date?

    -Uwe-
  21. Replies
    3
    Views
    60

    The car is definitely supported. Something is...

    The car is definitely supported. Something is wrong there. Let's start with the most basic items:

    Is your ignition on?

    If so, what is the exact result when you click [Options] -> [Test]?
    ...
  22. Replies
    5
    Views
    112

    In some ways it is, and in some ways it isn't. ...

    In some ways it is, and in some ways it isn't.

    On older, non-UDS modules, the reason you see "factory specs" (which are by no means universally available on those modules) is because we were able...
  23. Replies
    4
    Views
    235

    I've adjusted the thread title. -Uwe-

    I've adjusted the thread title.

    -Uwe-
  24. Replies
    10
    Views
    250

    Are you sure you are measuring the values...

    Are you sure you are measuring the values correctly?

    https://www.ross-tech.com/vag-com/cars/images/rim.jpeg

    Is the front really sitting 47 mm lower than it should be? That's quite a lot!
    ...
  25. Replies
    9
    Views
    207

    There's fume-free variety (blue label as opposed...

    There's fume-free variety (blue label as opposed to yellow) but I suppose it's probably somewhat less effective.
    ...
Results 1 to 25 of 479
Page 1 of 20 1 2 3 4