Search:

Type: Posts; User: vodonnell

Search: Search took 0.00 seconds.

  1. Do you have a leak in the headlight that might be...

    Do you have a leak in the headlight that might be allowing moisture in, had simerler problem with rear led lights on a 09 audi a6.
  2. Replies
    2
    Views
    822

    You need to put up a auto scan...

    You need to put up a auto scan.
  3. Thread: Battery.

    by vodonnell
    Replies
    5
    Views
    982

    Under the engine hood on the drivers side near...

    Under the engine hood on the drivers side near the bulkhead + has a red plastic cover.
  4. Replies
    6
    Views
    3,776

    Looks like a wiring issue can the wire to the...

    Looks like a wiring issue can the wire to the modules carry the load are grounds good.
  5. Thread: Brake issue

    by vodonnell
    Replies
    18
    Views
    13,857

    I have a 09 audi a6 with abs and eps used the...

    I have a 09 audi a6 with abs and eps used the pressure method as described in the vw literature to change break fluid no problems and straight forward would recommend it, are your calibers in good...
  6. You may put up a full auto scan or Jack will chew...

    You may put up a full auto scan or Jack will chew your ass!!
  7. Replies
    15
    Views
    4,091

    sounds like a bad ignition switch, rig up light...

    sounds like a bad ignition switch, rig up light bulb from ignition feed to see if it go out when car stalls.
  8. You need to put up a auto scan or you will be put...

    You need to put up a auto scan or you will be put to death.
  9. Replies
    5
    Views
    1,975

    Might be worth starting with a compression test...

    Might be worth starting with a compression test and cam to crank timing, fuel pressure at rail then smoke test the inlet manifold, good luck.
  10. They have a small reservoir that uses mineral oil...

    They have a small reservoir that uses mineral oil type is marked on the cap.
  11. Replies
    10
    Views
    5,880

    Over pressure switch G65 is saying that the...

    Over pressure switch G65 is saying that the system is overpressurised 33bar static is very high, put on a set of refrigeration gauges on the high and low sides and check actual pressure.
  12. You will need to post a autoscan if you want to...

    You will need to post a autoscan if you want to get any meaningful help with your problem.
  13. I think you need to go back to basics is your...

    I think you need to go back to basics is your timing setup correct, have you got compression, Irish garage equipment in Rathcool can supply a compression kit at reasonable cost you just need to...
  14. Replies
    4
    Views
    1,989

    Fault codes tend to be very accurate these days,...

    Fault codes tend to be very accurate these days, check glow plug on cylinder 3 and its connections replace if faulty.
  15. Replies
    31
    Views
    9,427

    If you have good compress and fuel at the right...

    If you have good compress and fuel at the right time it will start, what are you missing??
  16. Well known failure on Opel/Vauxhalls hatch backs...

    Well known failure on Opel/Vauxhalls hatch backs which is the same type of design replace switch.
  17. Would you have a photo or drawing of that fix...

    Would you have a photo or drawing of that fix Jack? regards Vinnie
  18. Replies
    18
    Views
    9,274

    You will need to put up a auto scan.

    You will need to put up a auto scan.
Results 1 to 18 of 18