Search:

Type: Posts; User: HMC

Page 1 of 8 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    10
    Views
    104

    Hi Johne, " I have no intention of paying for...

    Hi Johne,
    " I have no intention of paying for information from any commercial enterprise.". Yet you are prepared to pay for a used part you may not need. As Uwe would say "colour me confused"!...
  2. Replies
    5
    Views
    295

    You could connect it to a low pressure gauge and...

    You could connect it to a low pressure gauge and see what happens.
    Regards HMC
  3. Replies
    6
    Views
    164

    Hi Radovan, Is this definitely a low oil...

    Hi Radovan,
    Is this definitely a low oil pressure problem? Does the bonnet switch work?
    Regards HMC
  4. Replies
    5
    Views
    295

    Hi audi4ever, Are you sure your vacuum pump is...

    Hi audi4ever,
    Are you sure your vacuum pump is ok and holding vacuum?
    Regards HMC
  5. Replies
    8
    Views
    203

    The clockspring doesn't explode, at least it's...

    The clockspring doesn't explode, at least it's not deigned to:). I have been in the trade 54 years, don't start me on calling suspension dampers shock absorbers!
    Regards HMC
    Regards
  6. Replies
    8
    Views
    203

    Hi Mari, For some reason many people miss-name...

    Hi Mari,
    For some reason many people miss-name the clock spring or module that carries the connection to the steering wheel airbag a "squib". It derives from an English name for a firework or small...
  7. Hi metwrench, Do not confuse a mounting rattling...

    Hi metwrench,
    Do not confuse a mounting rattling with engine knock which is caused by incorrect combustion. Are you happy the fueling is correct? Are you using good fuel?
    Regards HMC
  8. Thread: Hi all!

    by HMC
    Replies
    7
    Views
    274

    Hi Jaan, " Do you happen to know if I am also...

    Hi Jaan,
    " Do you happen to know if I am also able to save the documents to PDF instead of printing them? " Yes there are several "print to PDF" programs available including an inbuilt Win 10 one. A...
  9. Hi gomarota, "is all about j519 Onboard supply...

    Hi gomarota,
    "is all about j519 Onboard supply control unit ( the unit i replaced)"
    Did you check it had the correct power and earths?
    Regards HMC
  10. Hi Gapel3, What have you done to check for boost...

    Hi Gapel3,
    What have you done to check for boost pressure leaks?
    Regards HMC
  11. "if the "cure" (i.e. the forced shut down of the...

    "if the "cure" (i.e. the forced shut down of the free world's economy, which doesn't really cure anything at all) isn't worse than the disease."
    23 Italian doctors have sadly died after catching the...
  12. Replies
    7
    Views
    273

    HI Rmoor3, Front and rear brakes do not have...

    HI Rmoor3,
    Front and rear brakes do not have equal pressure, as the rear brake would try to lock all the time. Yes this does sound like the ABS module, Vauxhall Corsa D's have a common problem just...
  13. Hi PetrolDave, I don't know what it is like in...

    Hi PetrolDave,
    I don't know what it is like in South Molton but if you don't believe that London is like a ghost town during the rush hour you are sadly deluded. My son sent a video of Westminster...
  14. Replies
    6
    Views
    282

    "with an oscilloscope under cranking and the...

    "with an oscilloscope under cranking and the waveform started rising". What voltage did it rise to? If you are suspecting a fault on the sensor signal wire you need to load test it at the ECU...
  15. Thread: Frequent DPF Regen

    by HMC
    Replies
    6
    Views
    292

    Hi SkilledMilk, What are the readings from the...

    Hi SkilledMilk,
    What are the readings from the Differential Pressure Sensor KOEO and at idle?
    Regards HMC
  16. Replies
    5
    Views
    189

    Hi Dan, Do the faults come back after clearing...

    Hi Dan,
    Do the faults come back after clearing in each module? Tried a battery reboot?
    Regards HmC
  17. Replies
    6
    Views
    282

    What is the fuel rail pressure when cranking? No...

    What is the fuel rail pressure when cranking? No pressure = no injectors!
    Regards HMC
  18. Thread: Damned Pirates.

    by HMC
    Replies
    6
    Views
    284

    Just because they are not white doesn't mean they...

    Just because they are not white doesn't mean they are not British.
    I have found undesirable human beings in all shades and creeds.
    If they were white would you have said " I best not mention who...
  19. Replies
    43
    Views
    1,936

    Hi Jack, "SPIRAL WRAP! ". Yes but he still needs...

    Hi Jack,
    "SPIRAL WRAP! ". Yes but he still needs to seal the wires to stop the green death!
    Bruce,
    Could you cut the affected wires further along the harness where you have a bit more room to...
  20. Replies
    8
    Views
    396

    "I’m in Cornwall but on the border with...

    "I’m in Cornwall but on the border with Plymouth."
    VCDS distributor Ilexa is in Truro.
    Regards HMC
  21. Replies
    30
    Views
    1,077

    "got the parts from an ebay listing...", so...

    "got the parts from an ebay listing...", so almost certainly not genuine VAG!
    Regards HMC
  22. Replies
    5
    Views
    218

    Hi SrapDodger, "Even so, I wouldn't have thought...

    Hi SrapDodger,
    "Even so, I wouldn't have thought that coolant temperature would affect fuel metering.". How wrong you are! You may not have driven anything with a manual choke which you had to...
  23. "Wish I can show you my facebook messenger not...

    "Wish I can show you my facebook messenger not making a living out of this"
    "VCDS Diagnostics
    Yet you have:
    Adaptation | Coding | Diagnostic | Retrofit - London, United Kingdom

    Authorised VW...
  24. Replies
    30
    Views
    1,077

    Hi maxx6v, ignition on engine not running (KOEO)...

    Hi maxx6v,
    ignition on engine not running (KOEO) the readings should be near enough atmospheric pressure (check with a barometer, Met Office etc), with the engine running depends on the state of...
  25. Hi James, We need a full Auto Scan, but I am...

    Hi James,
    We need a full Auto Scan, but I am assuming you have a diesel Crafter so no throttle body to align.
    Regards HMC
Results 1 to 25 of 185
Page 1 of 8 1 2 3 4