Search:

Type: Posts; User: Infiniteautotech

Search: Search took 0.01 seconds.

  1. Friday,05,October,2018,10:31:40:40922 VCDS --...

    Friday,05,October,2018,10:31:40:40922
    VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64
    VCDS Version: 18.9.0.2 (x64)
    Data version: 20180927 DS296.0
    www.Ross-Tech.com


    VIN:...
  2. 2006 GTI DSG codes P2711 - 004 and 005 after new mechantronic install

    Installed a new mechatronic unit in a 2006 GTI. Followed the filling procedure with temperature monitoring. Going the basic settings coding was correct 0000020. Group 061 switched to OK. Group 60...
  3. BTW, thanks for the technical explanation. That...

    BTW, thanks for the technical explanation. That was a great read!
  4. The difficult part was thinking and what we...

    The difficult part was thinking and what we needed to start. Now, after this experience, I would look at those values. But, I searched high and low and no one seems to have seen this situation...
  5. I wasn't aware an auto scan shows the temperature...

    I wasn't aware an auto scan shows the temperature readings but just the codes in each module which there were none? It would have been hard to scan the channels of the engine module not knowing what...
  6. OK, so the problem is solved. Replaced the...

    OK, so the problem is solved. Replaced the engine coolant sensor and the car starts correctly every time. I didn't ohm out the old sensor, but it must have been sending a bad signal making the ECU...
  7. Regarding the added jumper, I feel the voltage...

    Regarding the added jumper, I feel the voltage with out it is still high enough that the car should always start. We are still looking at 10.7-9 volts during cranking. With the jumper, we are...
  8. I have performed quite a few auto scans on the...

    I have performed quite a few auto scans on the car. There are no codes. I did change the ignition switch. That was the first thing that I did. I have verified spark and fuel too.
  9. 2007 A3 3.2L always cranks but intermittently does not start until key is released

    I've got an Audi A3 3.2L that will always crank, but the key must be released for it to start. This condition is worse if the car has been sitting. After the car is started, it will start normally...
  10. OK, here is the autoscan of the vehicle. Again,...

    OK, here is the autoscan of the vehicle. Again, after activating the TMPS function, I cannot reset the system using the VAG-COM. I see RESET in the drop down but no "DO IT." Any help would be...
  11. Thanks Uwe. I will get the car in again and grab...

    Thanks Uwe. I will get the car in again and grab an autoscan.
  12. Hoping I could get some help here. I...

    Hoping I could get some help here. I coded/activated a 2005 Canadian Rabbit via ABS control module to the 7K6 TMPS as the car is now in CA, USA. The TPMS light on the cluster now illuminates. ...
Results 1 to 12 of 13