Search:

Type: Posts; User: myounus

Page 1 of 20 1 2 3 4

Search: Search took 0.16 seconds.

  1. Byte 18 is always a nightmare. Try 1A

    Byte 18 is always a nightmare. Try 1A
  2. Replies
    11
    Views
    209

    I'm not at home to check on ETKA but you can look...

    I'm not at home to check on ETKA but you can look on the motor itself or give your reg/VIN to your local TPS and they'll give you a price and part number. What year is your car?
  3. If when measuring distance then it could be...

    If when measuring distance then it could be either sensor or wiring fault. Take them off and put them back on one by one and test to see if the error still happens. This way you can diagnose which...
  4. "Kind of exposed??" Did you cut them/damage...

    "Kind of exposed??"
    Did you cut them/damage them? The plastic sheath is pretty sturdy and water resistant. Did you expose the copper wire connections? Have you replaced any wires? Please could you...
  5. This is very strange as the parking sensor...

    This is very strange as the parking sensor connections are water tight and no water ingress should cause the faults shown on the 1st scan. Does it happen as soon as the parking sensors are engaged or...
  6. As I previously asked can you delete ALL FAULTS...

    As I previously asked can you delete ALL FAULTS and run a new scan please. This will assist us to help you

    Thanks
  7. Replies
    5
    Views
    181

    Buy yourself a cable. You're not only paying for...

    Buy yourself a cable. You're not only paying for a wire but the support! It's not actually expensive. One visit to the dealers these days costs almost the same as an enthusiast's cable. They don't...
  8. Hi Please could you clear all the faults and...

    Hi

    Please could you clear all the faults and post a new scan. This will allow us to see what faults are actually there.

    Thanks
  9. Replies
    11
    Views
    209

    Mmm. When you press the button can you hear the...

    Mmm. When you press the button can you hear the motor spinning? If so then it's likely to be mechanical, if not then it's a case of removal and testing the wires for power.
    Sometimes removal and...
  10. The issue is likely related to the gateway,...

    The issue is likely related to the gateway, testing of the BCM didn't produce any issues. Try flashing it back to AA and re-paramaterise.
  11. Oh dear. Try and locate the source of the water...

    Oh dear. Try and locate the source of the water leak and plug that too.
  12. It's difficult working out a way without the...

    It's difficult working out a way without the Gateway throwing up an error. There is a different method you can use where a memory chip is wired onto the start/ stop button that 'remembers' the last...
  13. It's going to be a case of trial and error. Try...

    It's going to be a case of trial and error. Try activating:
    IDE04159-Deactivation of start-stop function,Mode not active ,1
  14. Yes that's correct. STG is short for steuergerät...

    Yes that's correct. STG is short for steuergerät which is German for module. So you are correct and 19 is CAN GATEWAY or J533.
  15. The gateway is new in this model and there is...

    The gateway is new in this model and there is currently not a known method to disable it.

    Please post a map of STG19 so we can see what adaptations there are.

    Thanks
  16. Replies
    5
    Views
    109

    Post it on this website.

    Post it on this website.
  17. Replies
    11
    Views
    209

    Can you post a scan please. If the motor's gone...

    Can you post a scan please. If the motor's gone it should point to an electrical failure
  18. Replies
    2
    Views
    203

    Hi You need to activate 01 Engine byte3 bit 5,...

    Hi

    You need to activate 01 Engine byte3 bit 5, 03 ABS byte 26 to either 50 or F0.
  19. Hi I am currently investigating a similar...

    Hi

    I am currently investigating a similar issue where the rear window defogger ceases to operate with the change of a BCM. Have you paramaterised your BCM to a similar vehicle, i.e. one with PR...
  20. Replies
    5
    Views
    359

    Can you please clear all faults and please post...

    Can you please clear all faults and please post an updated scan. I take it you are referring to the Gateway installations. If you've updated to the correct gateway then the additional installations...
  21. Hi Please post a scan for reference purposes,...

    Hi

    Please post a scan for reference purposes,

    Thanks
  22. Replies
    7
    Views
    280

    Hall of shame

    Hall of shame
  23. Please post an autoscan. If you've got battery...

    Please post an autoscan. If you've got battery drain then you'll need to test one by one.
  24. increased safety of course. Ah well if they can...

    increased safety of course. Ah well if they can rob the motorist at the same time why not.
    If they really wanted to increase safety they'd incentivise car handsfree kits and won't fine the motorist,
  25. All of these systems work together on the CAN....

    All of these systems work together on the CAN. All ADAS systems run in conjunction with one another and they are linked into the vehicle's electrical systems to enable certain operations. When one...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4