Search:

Type: Posts; User: siLc

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. On a VW PQ platform vehicle, removing the battery...

    On a VW PQ platform vehicle, removing the battery is pretty much inevitable when the trans has to come out - the battery tray is sitting on the trans side mount.
  2. Thread: Door issue

    by siLc
    Replies
    4
    Views
    115

    Model year 2015 vehicle - I wouldn't call it that...

    Model year 2015 vehicle - I wouldn't call it that old to be already weary of wiring loom troubles in the door loom boot between the chassis and door.

    There's the fault but does it have any real...
  3. Replies
    3
    Views
    105

    By APS you mean "automatic parking sensors"? This...

    By APS you mean "automatic parking sensors"? This is usually known as PLA ("park-lenkung assist" in German).

    On the A3 8V the retrofit of PLA from 8K PDC should be pretty straightforward. Install...
  4. Besides the different AFS modules on the lights...

    Besides the different AFS modules on the lights themselves and the addition of DRL power modules, the main AFS module itself is a different part also - 5M0907357F instead of 6R0907357 you currently...
  5. Replies
    5
    Views
    149

    The new PDC module is on another of the car's CAN...

    The new PDC module is on another of the car's CAN networks, which is sepearate from the one the current old module is on. Hence the need to rewire. Fortunately its only 2 wires.

    You would need to...
  6. Replies
    19
    Views
    534

    You'll have to run Comfort CAN to the driver's...

    You'll have to run Comfort CAN to the driver's seat anyway to get memory to work. If this seat also has ventilation, the ventilators are LIN submodules of the BCM, so there's wires to run for these...
  7. Replies
    5
    Views
    149

    The old PDC control unit at address 76 doesn't...

    The old PDC control unit at address 76 doesn't support the OPS (Optical Parking System) feature. You would need to replace the module with a newer one and rewire the CAN connection from (IIRC)...
  8. Replies
    4
    Views
    173

    With module 20 HBA, you can't activate these...

    With module 20 HBA, you can't activate these features. Its logical you can't find module A5 as your vehicle does not have it.

    If you want these features, you'll have to buy the A5 module 3Q0980654...
  9. Replies
    9
    Views
    291

    If suspecting a parasitic battery drain, I'd look...

    If suspecting a parasitic battery drain, I'd look at that aftermarket radio.
  10. Some new variation of the MQB BCM? The A5...

    Some new variation of the MQB BCM?

    The A5 module clearly doesn't have any light assist functions coded. Change last Byte of A5 coding to "40". There might be other coding and BCM adaptation...
  11. With B6/B7 keys, before matching a virgin key...

    With B6/B7 keys, before matching a virgin key will need to be pre-introduced to the CCM. This can be done with an Avdi (or something like that) tool. Only after that can the new key (not virgin...
  12. As is usual, VW/Audi is the master of having not...

    As is usual, VW/Audi is the master of having not an inch of unused wiring in their vehicles. So definetly running appropriate wires is in order. As for getting wiring from a donor, usually parking...
  13. Replies
    13
    Views
    520

    Nope, still not the transmission code, only the...

    Nope, still not the transmission code, only the gearbox bell housing part number, which a a lot of gearbox codes share.

    Anyway, in Elsa I looked through the 0AJ gearbox allocations and drive...
  14. From the scan, engine code is CDAA, which is 1.8...

    From the scan, engine code is CDAA, which is 1.8 TSI, not 2.0 TFSI. Pretty much the same engine though. Perhaps HPFP faulty?
  15. Replies
    13
    Views
    520

    Perhaps first step is to find out from which...

    Perhaps first step is to find out from which donor car the gearbox is from and/or the gearbox code, in order to find out it's gear ratios. If the markings on the bell housing are ground down, then...
  16. Replies
    13
    Views
    520

    If no gearbox in scan, then its usually a manual...

    If no gearbox in scan, then its usually a manual box :)

    Factory gearbox code (3 letters) can be found from the vehicle data sheet near spare wheel in trunk and beginning of service handbook. The...
  17. There are so many faults in the "new" steering...

    There are so many faults in the "new" steering rack I would clear all faults and see what reappear...and post an autoscan with English-language VCDS.

    If the new rack is good, it would be...
  18. Replies
    13
    Views
    640

    Are the seats fully electric? From the factory,...

    Are the seats fully electric? From the factory, these have their own diagnostic addresses 06 and 36. Since these are completely missing in your autoscan, I'd presume these seats are retrofitted at...
  19. This just sounds like a simple coding issue with...

    This just sounds like a simple coding issue with the BCM or SWCM. Check the measuring blocks of SWCM (module 16) of what the SWCM is seeing while you're manipulating the indicator stalk to engage and...
  20. Please expand on how the halogen high beams do...

    Please expand on how the halogen high beams do not work as intended.

    As for relays, the lighting on this model is fully digitally controlled in the BCM - no relays.
  21. Replies
    2
    Views
    142

    Windows won't work from door switches unless the...

    Windows won't work from door switches unless the ignition is on but the fault in SWCM implies the window modules might not know if the ignition is indeed on.

    According to the info at hand,...
  22. Replies
    8
    Views
    335

    Module 09 is not known as "comfort module", but...

    Module 09 is not known as "comfort module", but CECM (central electric control module). If you installed a midline CECM instead of previous highline CECM, you can't front fogs to work unless you...
  23. Replies
    11
    Views
    1,019

    https://www.kufatec.com/en/volkswagen/vw-passat/pa...

    https://www.kufatec.com/en/volkswagen/vw-passat/passat-b8-3g/adapter-for-led-to-led-with-cornering-light-for-vw-passat-b8-42225 <- this adapter?

    High LED headlights have CAN between the lights and...
  24. Thread: AFS wiring

    by siLc
    Replies
    8
    Views
    286

    What is the part number of the AFS module? I...

    What is the part number of the AFS module?

    I wouldn't be so sure the CAN gateway even supports the Extended CAN. So having wired the AFS into CAN pins 7 and 17 - were the pins vacant? If yes, then...
  25. Thread: AFS wiring

    by siLc
    Replies
    8
    Views
    286

    Look closer, this vehicle is the older PQ...

    Look closer, this vehicle is the older PQ platform Tiguan - no footwell connection point in those :)

    Someone omitted an important detail from the schematic. See the *5 in the AFS module CAN...
Results 1 to 25 of 477
Page 1 of 20 1 2 3 4