Search:

I think so to do with wiring. Have you add wires?

Ok! No problem

Send me PM. I tell you how to do.

Friend. I have often use 4B used modules. Coding stays same. If not
Use odis to make coding by vin :)

The LWR must be connected otherwise the basic setting can't be done. LWR needs to be connected to the BCM in no case of 14 Suspension Electronics. Otherwise to the J250. AFS can work without the A5....

Buy used parts, then no param is needed in most cases. If you use new parts or parts from other cars, models I mean then there is a possibilty it won't work.

There are some important things about these headlights. These are fully CANBUS controlled. That means: turn, DRL, high beams and parking lights are totally functioned by canbus. This needs to be...

Today i have done this to Skoda Suberb. Ordered a complete set at Kufatec. Support is ****. In first time no work. Then I have test the guide here above and worked like a charm.

Please try those...

Flash to AJ 1244

This is coding from GTD facelift with OEM AID:

Address 17: Instruments (J285) Labels:| 5G0-920-XXX-17.clb-SRI3
Part No SW: 5G1 920 791 A HW: 5G1 920 791 A
Component: KOMBI ...

Flash gateway to newer version.

Need add LVDS wire

8W is B9 friend.

Only for audi a4 8k model parameterize is needed. For 8w model not just coding only. Done a lot of times!

That is correct 1x with both wires together must be ok with 30a

No need coding for canbus wires. Yes I know, but they are needed for proper work, also for interior lights

Hello Timmy. I see you upgrade to max BCM. You need to run wires to make everything work ok. You need to make new wires for Instrument and also Supply for bcm.

For instrument to need 2 new canbus...

Try to remove CP from 5F. As I see coding must be in byte 4-7 "00" and byte 11 "02".
Therefore byte 19 "bit 5 MOST Databus" must also be on.

After all this try to reset, and sound must be up...

Hello,

I have other question. Can you provide me adaptionmaps of 09? I retrofit this headlights. Hope you can help me.

Regards

As far as I can see its a hybrid cluster. You need 791

Yes it possible

No cannot only with ODIS and GEKO account

Turn signal is same. Need to run wire for brake lights

There are couple people who can do this by remote. Exactly what Downtime says normally is controlled by factory enabeling.

Hello. Your headlight range module is not ok. You can use 2 types of modules:
- 8V0 907 357 with or without index A
- or 3Q0 907 338

I use normally the first one. This module controls the LED...