Search:

Type: Posts; User: ai_Ingo

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Yes thank you. I've already seen that. I spent a...

    Yes thank you. I've already seen that. I spent a long time looking for the cause of the first case and luckily I got the tip from Audi. There were about 24 control units in the A7 with different...
  2. Yes, because this part is also used in other...

    Yes, because this part is also used in other vehicles mainly for the heating circuit.
  3. Incidentally, Audi has known this problem for...

    Incidentally, Audi has known this problem for years. I've worked for Audi in a car dealership for 27 years. It is just that in the technical product information, I think it is called service bullitin...
  4. Hi, please also check the connector on the engine...

    Hi, please also check the connector on the engine control unit, in the cases I had, there was some moisture in the connector for some.
    The spare part number you are showing is correct.
  5. Hi, I think this could actually be the case where...

    Hi, I think this could actually be the case where the coolant valve lets the cooling water through the wiring harness to the control unit. But you need a lift to get to the valve.
  6. I absolutely agree with Dana. I had the problem...

    I absolutely agree with Dana. I had the problem with a leaky high pressure pump more than once.
  7. Replies
    18
    Views
    982

    Hi,if the vehicle is on the sidewalk edge, this...

    Hi,if the vehicle is on the sidewalk edge, this has no effect on the function. Precisely it means: towing protection The transmitter / receiver module 1 for interior monitoring master is the encoder...
  8. Replies
    8
    Views
    268

    Hi, please check communication in control unit 19...

    Hi, please check communication in control unit 19 in the measuring blocks, block 132,3 as shown:
    132,0,CAN-Databus Comfort (Communication)
    132,2,Steering Wheel,Electronics (J527),Range: St. Wheel...
  9. Replies
    7
    Views
    2,041

    Please check the crankcase ventilation on the...

    Please check the crankcase ventilation on the valve cover. I know that sounds strange, but if the membrane leaks, there may be a slight drop in oil pressure. I had this case very often during my time...
  10. I would maybe first look with a vacuum pump and...

    I would maybe first look with a vacuum pump and an external hose to see if the vacuum holds on to the turbocharger and whether the linkage moves slightly to the stop. If so, please drive with the...
  11. I meant that it can happen quickly that you make...

    I meant that it can happen quickly that you make a mistake when connecting the hoses. I probably hadn't read correctly and overlooked the fact that your problem existed before you replaced the valve,...
  12. Hi, please check the gearbox cooling valve N509....

    Hi, please check the gearbox cooling valve N509. Check if there is water in the electrical plug. If yes, replace it. The water goes from the valve through the cable to the plug of the gearbox.
    The...
  13. Hi, when I look at the Freeze Frame, it does not...

    Hi, when I look at the Freeze Frame, it does not indicate any boost pressure. Are all relevant vacuum hoses attached? The turbocharger is a VTG charger, it needs negative pressure to build up the...
  14. Replies
    4
    Views
    229

    Just as Patrol Dave wrote, clean or replace the...

    Just as Patrol Dave wrote, clean or replace the DPF. Then the DPF must be reset with VCDS. But this can only happen if it has either been cleaned or replaced. An overloaded DPF that is reset could...
  15. Replies
    4
    Views
    229

    Hi, if i remember correctly, the maximum value is...

    Hi, if i remember correctly, the maximum value is 40 grams for the service regeneration. In your case the calculated soot mass is at 42.23 grams. I think that's the reason why it is canceled for...
  16. Replies
    0
    Views
    3,145

    Porsche Cayenne 2020

    Montag,09,März,2020,08:12:44:12790
    VCDS -- Windows-basierter VAG/VAS-Emulator läuft auf Windows 10 x64
    VCDS Version: DRV 19.6.2.1 HEX-NET CB: 0.4508.4
    Datenstand: 20191020 DS308.0...
  17. Hi, if you have a circuit diagram, please check...

    Hi, if you have a circuit diagram, please check whether the components use a common ground. At the same time the power supply.
  18. Thank you, you're absolutely right. I just...

    Thank you, you're absolutely right. I just checked that. I really still thought about the old model.
  19. Hi, if you only want to change the brake pads,...

    Hi, if you only want to change the brake pads, not the handbrake pads or the brake discs, then definitely do not use vcds to remove the brake. It leads to the fact that you have to carry out a basic...
  20. Replies
    8
    Views
    491

    Hi, the air quality sensor is located close to...

    Hi, the air quality sensor is located close to the wiper motor. In my view, it has nothing to do with your problem. I think that either a sensor for outflow temperature or the sensor for sun position...
  21. Hi, please disconnect the battery again for a few...

    Hi, please disconnect the battery again for a few minutes, then connect it again, please note that the voltage must be above 12 volts. If so, drive, turning the steering wheel all the way to the left...
  22. Replies
    17
    Views
    1,381

    Ok, let me know what the problem was. I wish you...

    Ok, let me know what the problem was. I wish you best luck.
  23. Replies
    17
    Views
    1,381

    Well be happy if not... it could meen thet the...

    Well be happy if not... it could meen thet the main crankshaft bearing has too much play (axial). In the case of a left-hand curve, the crankshaft moves to the right, which creates greater play on...
  24. Replies
    17
    Views
    1,381

    Hi, does it happen when you drive a left turn?

    Hi, does it happen when you drive a left turn?
  25. Hi, the engine runs with vacum in the crankcase....

    Hi, the engine runs with vacum in the crankcase. A known problem is crankcase breather placed on top of the valve cover. I think the memrane in the crankcase breather has a crack. wich would cause...
Results 1 to 25 of 27
Page 1 of 2 1 2