Search:

Type: Posts; User: siLc

Page 1 of 17 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    14
    Views
    208

    Almost every module's part number begins with 8W...

    Almost every module's part number begins with 8W in the vehicle's autoscan.

    Chassis type at the start of every autoscan used to be a good indicator of the vehicle model but it no longer is...
  2. Replies
    8
    Views
    132

    The fault codes in the transmission pretty much...

    The fault codes in the transmission pretty much tell the tale of the common mechatronic fault of the DQ200 DSG. The pressure accumulator valve housing inside the mechatronic develops cracks and...
  3. Replies
    14
    Views
    208

    A4 B9 is otherwise known as "Type 8W". You'll see...

    A4 B9 is otherwise known as "Type 8W". You'll see it many modules of your own autoscan.
  4. Replies
    6
    Views
    552

    The rear DCC sensor should be bolted down. If the...

    The rear DCC sensor should be bolted down. If the DCC controller plug is smashed up, you can probably salvage the connector pins inside it and buy a new plug. Wiring itself should be doable with a...
  5. By posting your autoscan, you made it possible...

    By posting your autoscan, you made it possible for us to see whats installed in the car, and with hadez16's CodingCompare tool and a custom label file for the A5 front camera, come up with a coding...
  6. A5 coding should be...

    A5 coding should be 000408020000040100061344C050A10094000E200020

    Since this vehicle has 5F navi and PLA 3.0, PSD (Byte 10), VZE (Byte 16, Bit 4) and PLA can also be coded in A5.
  7. It would be wise to finish installation and...

    It would be wise to finish installation and coding before attempting calibration. Also the camera software is really old - if you can, have it updated to at least revision F (3Q0 980 654F) or later.
  8. "Fighting" the CAN gateway on a B8 is relatively...

    "Fighting" the CAN gateway on a B8 is relatively easy compared to a B7 :)
  9. Factory fuse location for the front camera is...

    Factory fuse location for the front camera is SC32. This fuse position is shared with ACC radar and parking aid module. If you only want to add the front camera and want to save time, I'd suggest...
  10. Replies
    292
    Views
    149,162

    The tow bar itself may be rated for such and such...

    The tow bar itself may be rated for such and such but another thing is how much the particular vehicle model is rated to tow? This varies from engine to engine, with the 2.0 TDI usually being rated...
  11. The upper A-pillar trim clip is a one-time use...

    The upper A-pillar trim clip is a one-time use part. Simply buy a new one from a dealer. Part number 3G0867280, ~1,8€ a piece.
  12. Yes, this is correct.

    Yes, this is correct.
  13. Replies
    5
    Views
    107

    On this platform, only address 46 handles the...

    On this platform, only address 46 handles the factory alarm functions. No use in checking 09.
  14. Replies
    2
    Views
    71

    It's a 'virgin' camera which will need also to be...

    It's a 'virgin' camera which will need also to be parameterized and calibrated, in addition to coding.
  15. Replies
    11
    Views
    206

    I noticed this vehicle still has a CECM instead...

    I noticed this vehicle still has a CECM instead of BCM, but the same still applies. Though it's statistically unlikely that both plus wires for the front blinkers went out simultaneously. I'd hazard...
  16. Replies
    11
    Views
    206

    If the stalk were to blame you wouldnt have any...

    If the stalk were to blame you wouldnt have any blinkers at all. An appropriate DTC is stored in the BCM (module 09) so there’s probably a wiring problem between the headlights and the BCM.
  17. Replies
    9
    Views
    220

    I meant the sensors see through a plastic trim...

    I meant the sensors see through a plastic trim piece (usually a grille) to monitor the car interior. Perhaps sensor 2 is out of place and is monitoring a plastic piece inside the headliner, instead...
  18. Replies
    9
    Views
    220

    The alarm sensor module 5Q0 951 172 has three...

    The alarm sensor module 5Q0 951 172 has three sensors. If one is implausible, perhaps check its installation - is it secured in it's proper place?
  19. Thread: Radio upgrade

    by siLc
    Replies
    9
    Views
    272

    Then I think this is not worth the hassle. I have...

    Then I think this is not worth the hassle. I have Discover Media and its navigation gets used only very seldom - because its inherently out of date, which online services like Waze aren’t.
  20. Thread: Radio upgrade

    by siLc
    Replies
    9
    Views
    272

    Well, with ODIS online CP matching, there's the...

    Well, with ODIS online CP matching, there's the question of how much of the Discover Media PQ's FeC features would survive the matching. FeC's such as navigation, BT, voice control etc, which the...
  21. Replies
    18
    Views
    2,990

    Isn't steering wheel vibration applicable to Side...

    Isn't steering wheel vibration applicable to Side Assist, not Lane Assist?

    My patient had PLA 3.0 but it was not the newer 5QA module. Don't remember changing its coding...
  22. https://www.ebay.co.uk/itm/VW-Passat-B7-CC-Color-c...

    https://www.ebay.co.uk/itm/VW-Passat-B7-CC-Color-cluster-3C8920981N-3C8920981M-3AA920981-3AA920981A/153542793993?hash=item23bfdd1b09:g:BCoAAOSwakxdEptX

    There doesn't seem to be a big aftermarket...
  23. Replies
    9
    Views
    185

    H index camera is suitable for TJA, if memory...

    H index camera is suitable for TJA, if memory serves. The camera will need to be reparameterized but you'll need the "other" tool for this.
  24. Replies
    20
    Views
    902

    Aah, I see. Googling with "drive2 dq500 passat"...

    Aah, I see. Googling with "drive2 dq500 passat" should net you some Passat B6-es from the drive2.ru site.

    A nice challenging retrofit. Good luck and keep us posted.
  25. Replies
    20
    Views
    902

    I wouldn't be surprised if this means a 3C8 CECM...

    I wouldn't be surprised if this means a 3C8 CECM to 3AA BCM retrofit. In theory, of course. I mean, all the cars having the DQ500 from the factory have a BCM.
Results 1 to 25 of 410
Page 1 of 17 1 2 3 4