Search:

Type: Posts; User: machado

Page 1 of 5 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    2
    Views
    121

    I removed the air box and found a few wires...

    I removed the air box and found a few wires running from boost sensor to ECU, i believe there are more broken wires but customer has denied any further work.
  2. Replies
    2
    Views
    121

    2013 Passat 2.0 p0405 egr circuit

    This Passat had the egr valve replaced not sure what the fault was at the time, but now sets po405 always sets at high speeds between 70 to 100 kms. It won set at idle or by wiggling the harness or...
  3. Thank you Peter, it all was good and I...

    Thank you Peter, it all was good and I delivered the car to the body shop they cleaned it and called me later and said the doors wont lock either key or button but will unlock. It will lock when...
  4. I replaced the BCM all good now, it started no ...

    I replaced the BCM all good now, it started no problem as soon as I plugged it in. I had to get it coded to the car, low tire light was on and remotes had to be learned. Thank you
  5. I didn't see any input for terminal 50 but I...

    I didn't see any input for terminal 50 but I removed the fuses for the ecu and engine cranked. It should not affect cranking right.
  6. Thanks Peter I have to leave car alone but I have...

    Thanks Peter I have to leave car alone but I have a couple of pics from bcm when problem was there and when it was working fine. Both picture were taken while key was in crank position. If the...
  7. This car has a key to turn to start no a push...

    This car has a key to turn to start no a push button. I removed trigger wire at the starter hooked up a light and if I hold key on crank power is there for ever as long as hold the key if car is...
  8. Thank you I will check for terminal 50 In ECU. I...

    Thank you I will check for terminal 50 In ECU. I know problem Is worse when key turned on quickly and address 09 terminal 50(can output BCM) shows off while can input ZAS shows on while cranking. I...
  9. 2014 Tiguan no crank, no power to the starter

    This car was involved in a front collision new air bags, module, turn signal and wiper sw also replaced because they were damaged from air bag deployment. Customer said this problem was there before,...
  10. Replies
    4
    Views
    242

    It sounds like a problem I the radio I tapped...

    It sounds like a problem I the radio I tapped the side of the dash and the radio turned back on, only did it one time and center button is very sensitive, slight movement and radio turned on. I...
  11. Replies
    4
    Views
    242

    Not sure I know the carpet was cleaned. Thank you...

    Not sure I know the carpet was cleaned. Thank you Jack
  12. Replies
    4
    Views
    242

    2013 Q5 Radio wont turn off sometimes

    The customer claims that after having the car detailed sometimes the radio stays on after closing all doors and one time the hazards were on when he got to the car. The radio will eventually turn...
  13. Replies
    4
    Views
    502

    Thank you, its a Sanden compressor.

    Thank you, its a Sanden compressor.
  14. Replies
    4
    Views
    502

    2011 golf tdi ac compressor valve

    Saturday,30,June,2018,06:17:17:15785
    VCDS -- Windows Based VAG/VAS Emulator Running on Windows 7 x86
    VCDS Version: 18.2.1.2
    Data version: 20180518 DS287.1
    www.Ross-Tech.com


    VIN:...
  15. Replies
    2
    Views
    434

    2013 Passat tdi Regen issue

    This car had Egr faults a month ago and the heater core was replaced under warranty because it was plugged(tsb) Now I have these fault codes he said it ran rough. I drove it it runs fine now possible...
  16. Replies
    10
    Views
    2,493

    Thank you Dana, I still had the other car here in...

    Thank you Dana, I still had the other car here in the afternoon I checked the purple and white wire at clock spring plug the working car had data signal 0 to 11 volts, my car measured 0 volts. I...
  17. Replies
    10
    Views
    2,493

    I compared to another working car and same data...

    I compared to another working car and same data voltage, the difference was the horn sw had 5 volts and the steering multifunction control (little module behind air bag in the steering wheel) has a...
  18. Replies
    10
    Views
    2,493

    The drivers door sw has water damage that's the...

    The drivers door sw has water damage that's the reason the windows don't work. I checked for data signal at T16 under steering column I have a data signal that varies one
    wire from 2.47 to 4 volts...
  19. Replies
    10
    Views
    2,493

    2014 jetta Horn not working

    Tuesday,03,April,2018,06:11:33:15785
    VCDS -- Windows Based VAG/VAS Emulator Running on Windows 7 x64
    VCDS Version: 18.2.0.3 (x64)
    Data version: 20180212 DS287.0
    www.Ross-Tech.com


    VIN:...
  20. Replies
    10
    Views
    1,797

    That cake does look good

    That cake does look good
  21. Replies
    10
    Views
    1,797

    I replace the abs unit with a used one. Its all...

    I replace the abs unit with a used one. Its all good now, i used a pressure bleeder and i get good flow on all wheels. Pedal is good.Thank you, Mario
  22. Replies
    10
    Views
    1,797

    Thank you Jack, i tried it , but same results...

    Thank you Jack, i tried it , but same results right front always has low flow.
    I replace abs tuesday.
  23. Replies
    10
    Views
    1,797

    Thank you I did that, but no luck. Next week I...

    Thank you I did that, but no luck. Next week I will replace abs unit.
  24. Replies
    10
    Views
    1,797

    All lines are conected properly and are not...

    All lines are conected properly and are not restricted, my guess they pumped the brakes to the floor until foot was tired. I will try vacuum bleeding, pressure etc again. Thanks
  25. Replies
    10
    Views
    1,797

    2009 Audi A6 quatro, low brake pedal

    This A6 in a collision in left front. The body shop had remove all brake lines to do the body repair. No lines were damaged, they bled the system best they could. The pedal is a bit low. I tried...
Results 1 to 25 of 122
Page 1 of 5 1 2 3 4