Search:

Type: Posts; User: Dana

Page 1 of 20 1 2 3 4

Search: Search took 0.08 seconds.

  1. This is a Mk6 based / PQ35 BCM so I agree with...

    This is a Mk6 based / PQ35 BCM so I agree with the guys above. (Mk7 / MQB BCMs are an entirely different animal and they do require a SA code prior to adaptation.)

    You already have Byte 14, Bit 2...
  2. Dumb question, but that TPMS DTC is Confirmed...

    Dumb question, but that TPMS DTC is Confirmed Intermittent. Did you clear it with VCDS to see if it reoccurs?
  3. Replies
    8
    Views
    287

    3VWLZ7AJ2BM307556

    Hi,

    We're running a 2-tech support team this morning but I can take a crack at that coding at some point. Just to be clear, this is the VIN to the actual vehicle correct?

    3VWLZ7AJ2BM307556
  4. Replies
    55
    Views
    7,450

    Hi Gary, I located an earlier scan from you in...

    Hi Gary,

    I located an earlier scan from you in our email which contained this BCM:


    It might not hurt to post the scan here if you need any assistance but I'll redirect that BCM to an existing...
  5. Replies
    3
    Views
    155

    I don't have any contributions but you may find...

    I don't have any contributions but you may find the PDF linked in this thread helpful:

    https://forums.ross-tech.com/showthread.php?7680-0AM-DSG-Fault-codes-P173A-P173B-P173C-P173D-P173E-P173F
  6. The part numbers of 42 and 52 are significantly...

    The part numbers of 42 and 52 are significantly different, and I don't know if that alone is a major conflict, but I would try coding 52 to match 42: 0000048

    If that doesn't improve the situation...
  7. Replies
    6
    Views
    164

    Thanks for the VIN and Adv ID from Address 01:...

    Thanks for the VIN and Adv ID from Address 01: Engine.

    Please include the Adv ID data from addresses 17 and 25 as well so we can confirm WVWZZZ6RZEY202280 is stored in all of the Immo related...
  8. Replies
    6
    Views
    164

    N5ayl emailed this log clip which is believed to...

    N5ayl emailed this log clip which is believed to be the factory coding:


    Address 03: ABS Brakes (J104) Labels:. 6R0-907-37x-ESP90.clb
    Part No SW: 6R0 907 379 AS HW: 6R0 907 379 AS
    ...
  9. Replies
    8
    Views
    287

    Hi Joshua, That VIN decrypted as a 2012, and I...

    Hi Joshua,

    That VIN decrypted as a 2012, and I can easily tweak the forum subject line, but do verify the actual VIN is 3VWLX7AJ0CM463862 (to rule out swapped Immo components).

    If...
  10. Replies
    11
    Views
    371

    With the exception of extremely low (11.1 V)...

    With the exception of extremely low (11.1 V) voltage in measuring block group 001 your Terminal 30 readings appear to be perfectly fine. Both left and right are identical so I don't suspect a blown...
  11. Replies
    5
    Views
    268

    Thanks Magnus, I replied to your maps with ABS...

    Thanks Magnus,

    I replied to your maps with ABS EOL suggestions in the event that you have time to test that when the MFSW is installed.

    Next, as far as that momentary (or inverted) CCS position...
  12. There's a VW part number on that connector. Give...

    There's a VW part number on that connector. Give that number Google search and you should be able to locate the empty housing/connector easily. (You are looking for something like: 1J0 973 775 A)
    ...
  13. Replies
    12
    Views
    302

    I do not have any alternative coding suggestions...

    I do not have any alternative coding suggestions however I suppose it couldn't hurt to check Adaptation channels in the 44 module: http://wiki.ross-tech.com/wiki/index.php/01309

    It is highly...
  14. Replies
    12
    Views
    302

    Although it would be best to have the correct ABS...

    Although it would be best to have the correct ABS module installed I'm not very confident that it alone will resolve that 01309 - Power Steering Control Module (J500) - Implausible Signal DTC. ...
  15. Replies
    12
    Views
    302

    Thanks for the update and new scan. Please try...

    Thanks for the update and new scan. Please try the alternative coding in post# 5.
  16. Replies
    13
    Views
    576

    I didn't spend a lot of time searching but I...

    I didn't spend a lot of time searching but I found this NAR 2019 A4 scan in our emails:



    Address 46: Central Conv. (J393) Labels:* None
    Part No SW: 8W0 907 064 GC HW: 8W0 907 064...
  17. Thanks for posting the new map. Per a Compare...

    Thanks for posting the new map. Per a Compare It! of your maps the service related discrepancies appear to be.


    Old/Original condition
    IDE00512-ESI: minimum value km-driving...
  18. Replies
    12
    Views
    302

    P.S. If that's rejected this is my only other...

    P.S. If that's rejected this is my only other suggestion (modified 16/7): 163B600D092200FE681006E8901E00813000

    I failed to include the PR-codes earlier as well.





    Vehicle Identification...
  19. Replies
    12
    Views
    302

    We don't have many South African (special AAV...

    We don't have many South African (special AAV VIN) scans but this appears to be a pretty close baseline match: https://forums.ross-tech.com/showthread.php?8580-Long-Code-for-ABS-Golf-GTI_2009


    ...
  20. Replies
    3
    Views
    143

    I came up with: ...

    I came up with:

    433C200D092503FFC21004EB9022C081A0000020
  21. Replies
    3
    Views
    143

    I'm pasting PR-codes for now. I'll reply with...

    I'm pasting PR-codes for now. I'll reply with any coding suggestions in another post.




    Vehicle Identification No.

    WV1ZZZ2KZFX035579
  22. Replies
    3
    Views
    136

    That looks like a NAR market T'reg so the (old)...

    That looks like a NAR market T'reg so the (old) factory condition scan from my husband's 2017 NAR (7P) may be useful in regards to a handful of 09 and 55 coding bits in addition to the VIN to pull up...
  23. Hello, I won't be able to provide much...

    Hello,

    I won't be able to provide much assistance here but this vehicle cannot show MFSW functions under address 16. Instead, that's a slave of BCM/J519 as you mentioned:


    Subsystem 3 -...
  24. Replies
    4
    Views
    179

    We do not have any additional coding suggestions....

    We do not have any additional coding suggestions. If you send this one off to the dealer for online SVM coding please save a final scan so it can be posted here to improve documentation.
  25. Replies
    9
    Views
    216

    Neat. I'm ASSuming there isn't another oil temp...

    Neat. I'm ASSuming there isn't another oil temp input, and if so, I wonder if the cluster using using a filler value or default strategy? Similar to unplugging a MAF sensor and watching that MVB...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4