Search:

Type: Posts; User: MartinsX

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    38
    Views
    604

    Can't disagree... Readiness: 0000 0000

    Can't disagree...

    Readiness: 0000 0000
  2. Replies
    1
    Views
    34

    A lot of engine dtc's... I'd suggest to clear...

    A lot of engine dtc's... I'd suggest to clear them all and start with ones that come back first
  3. Replies
    16
    Views
    229

    But ok, if You said, LF is really physically...

    But ok, if You said, LF is really physically lower, then do couple other tests (on level surface, of course) - lower vehicle as low as it is possible, check all level measurements, and lift it as...
  4. Replies
    16
    Views
    229

    If we count one (what Jack wrote) plus one (Your...

    If we count one (what Jack wrote) plus one (Your measurements), what should we get? Maybe five? :D
  5. Replies
    16
    Views
    559

    Unfortunately it's not like old Polo 6N, where it...

    Unfortunately it's not like old Polo 6N, where it goes up to 300k and then restarts from 0 :D
  6. Replies
    4
    Views
    80

    Did You manually choose model/chassis or used the...

    Did You manually choose model/chassis or used the Auto Detect function?
    Looks like, it is 8K, not 8R


    VIN: WAUZZZ8KXFA144579

    Chassis Type: 8R0
    And 8K is A4 and 8R is Q5, no one is A6...
  7. Update - according label file only fog lights...

    Update - according label file only fog lights diagnosis (bad bulb warning) can be enabled/disabled in this module...
  8. It will not work. System is designed in a way...

    It will not work. System is designed in a way that current flowing to bulbs is monitored all the time, not only for some seconds after ignition on. You can test it in a simple way: reinstall the...
  9. Replies
    4
    Views
    271

    If new harness would cost 250, I would replace it...

    If new harness would cost 250, I would replace it with brand new one... But as it costs 10 times more, I would repair it.
    My suggestion is to repair all damaged wires first, if missfires are still...
  10. Check CAN wires, pay special attention to...

    Check CAN wires, pay special attention to connection point/splice on the floor near right B pillar. (You have to remove front right seat and some plastic trim parts and lift up floor cover to get...
  11. Replies
    1
    Views
    83

    Requested/specified boost pressure looks a bit...

    Requested/specified boost pressure looks a bit too high for me. Any chiptuning/ECU SW modifications done before? EGR removed, maybe? I'd reflash ECU with known good stock SW or swap it with known...
  12. Wiring info: - luggage compartment light (W3)...

    Wiring info:
    - luggage compartment light (W3) supply is separate output from BCM, T52a/3, red/blue wire. No additional load allowed to that output, I think.
    - constant voltage supply for interior...
  13. Anyway not completely clear where OP connected...

    Anyway not completely clear where OP connected the additional light. If OP could make a picture from original WD and draw by hand the extra connections?
  14. Replies
    10
    Views
    233

    Get the WD, check the "holly trinity" first -...

    Get the WD, check the "holly trinity" first - power, ground and data at ABS module connector.
  15. Replies
    39
    Views
    864

    First try to remove O2 sensor and clean it. No...

    First try to remove O2 sensor and clean it. No sharp tools and chemical cleaners allowed! Use soft brush and compressed air.
  16. Replies
    18
    Views
    518

    This product...

    This product helps not in all but a lot of cases ;) It works perfectly where DPF is mounted vertical, horizontal installations sometimes requires two attempts=two cans.
  17. Replies
    27
    Views
    613

    Nothing suspicious. Probably car was used as Taxi...

    Nothing suspicious. Probably car was used as Taxi before and it is speed pulse interface for taximeter installation.
    http://www.canm8.com/can-bus-interfaces/all-interfaces/canm8-pulse.html
  18. Replies
    4
    Views
    219

    Too much fault codes to be caused by faulty G70...

    Too much fault codes to be caused by faulty G70 ... I'd look for hole/source of unmetered air in intake/vacuum/PCV/EVAP systems
  19. Replies
    10
    Views
    198

    I'd like to have 038-906-016-BRS label in German,...

    I'd like to have 038-906-016-BRS label in German, too.
    P.S. Maybe its not a bad idea to include all existing label files in standard English version? If there is no English translation, then include...
  20. Replies
    27
    Views
    613

    But it (0x36) is online for VCDS, only GW...

    But it (0x36) is online for VCDS, only GW complains it is offline... CAN wires interchanged? I mean not H/L but module now is by some reason connected to powertrain or infotainment CAN instead of...
  21. Replies
    27
    Views
    613

    What kind of device was connected to CAN under...

    What kind of device was connected to CAN under seat? Post a photo, if possible. Does the 131660/U0208 00 keep coming back if deleted several times?
  22. Replies
    8
    Views
    228

    Hi! I"d start with basic mechanics. Let's get...

    Hi!
    I"d start with basic mechanics. Let's get more info for beginning. How the chain jumped? Why? Was it broken or only jumped for some teeth? How match? What else parts were damaged/are replaced?...
  23. Thread: VW cc 2013

    by MartinsX
    Replies
    5
    Views
    138

    Check for measurement of steering angle when...

    Check for measurement of steering angle when wheels are positioned straight. Should be around 0 degrees. If it shows + or - 360 or 720 degrees, try to remove it and turn to 0 position. If it does not...
  24. Replies
    4
    Views
    271

    I'd start with deeper investigation what caused...

    I'd start with deeper investigation what caused missfire codes for all bank 2 cylinders. Intake air or vacuum or pcv leak, maybe? Chain between camshafts or adjuster?
    New spark plugs if previous...
  25. Thread: VW cc 2013

    by MartinsX
    Replies
    5
    Views
    138

    Are any repairs done on steering rack/column or...

    Are any repairs done on steering rack/column or connected parts just before fault appeared?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4