Search:

Type: Posts; User: naushad2982

Page 1 of 6 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    6
    Views
    280

    Injectors will only start firing when a minimum...

    Injectors will only start firing when a minimum of 280 bar has been achieved on the fuel rail, Group 001 of the measured value blocks while cranking will give you fuel rail pressure readings.... ...
  2. Replies
    8
    Views
    823

    There you go ​ Special editions E15...

    There you go





    Special editions
    E15
    Club & Lounge
  3. Replies
    3
    Views
    868

    Hex V2 Cable not working

    Hello,

    My Newish HEX V2 dongle seems to have stopped working randomly in the middle of a session,

    Ran an auto scan on an A3 then tried to go into Central electrics and nothing,

    windows...
  4. Yes the POT works fine if te ecu return wire is...

    Yes the POT works fine if te ecu return wire is isolated, reconnect it back onto the ECU and it throws the signal back to Zero Volts
    logically that would be a faulty ECU. BUT!! ive tried another ECU...
  5. 1) Yes I have tried a new accelarator pedal, same...

    1) Yes I have tried a new accelarator pedal, same error,
    2) i have run overlay wires on the return wire for G79 and the radiator output sensor after cutting off the original wiring of completely...
  6. 2014 Amarok Accelarator pedal and Radiator Temp sensor error

    hello guys,
    i have the above vehicle with a very peculiar fault.

    I am Getting these two errors



    2813 - Accelerator Position Sensor (G79)
    P2122 00 [167] - Signal too Low
  7. Replies
    1
    Views
    209

    RS4 B7 Intermittent starter fault

    Hey guys,

    I have a 2007 B7 RS4 that has a random starter failure (start button doesn't do anything) So far is has a new starter, new starter relays, new (aftermarket) clutch switch and new starter...
  8. Replies
    2
    Views
    182

    2008 Passat ABS Coding request

    Hey guys,

    I have a 2008 Passat that has the Park brake control Module replaced. the vehicle was brought from another workshop with different park brake modules
    fitted so i couldn't save the...
  9. Replies
    2
    Views
    280

    2011 Passat CC Xenon failure

    Hey guys I have the above vehicle that has a Xenon failure,

    When you switch the lights on both lamps go on properly and stay on for about a minute,

    after that they both Go off simultaneously,
    ...
  10. 2013 A6 Allroad (4G) Level control error

    hey guys,

    I have here an A6 Allroad that has a rear level control error

    if the vehicle is left standing on its highest setting for upto 3 weeks it maintains the level perfectly, so no leaks
    ...
  11. Replies
    8
    Views
    614

    the red pipe is quick release, you push the red...

    the red pipe is quick release, you push the red tab inwards and the pipe comes off leaving the nut on, the dryer will be for generation 2.

    update on the car, pumped in up yesterday, closed off...
  12. Replies
    8
    Views
    614

    SO decided to make my own leak tester. it allows...

    SO decided to make my own leak tester. it allows me fill the line with an external source, and most importantly it has a gauge and shut off valve to isolate the line and measure for any leaks.
    ...
  13. Replies
    8
    Views
    614

    ok so i used the basic settings to 1st deflate...

    ok so i used the basic settings to 1st deflate the entire vehicle and secondly pump it back up in turn, the car did as t should and i managed to drop the rear down and raise the front and get the car...
  14. Replies
    8
    Views
    614

    2006 Audi A8 Air suspension error

    Hey Guys,

    I have a 2006 Audi A8 that has a suspension issue. The front has dropped entirely and the rear has lifted up completely.

    About 2 months ago we replaced both front air spring...
  15. the car will stay upright if left parked for upto...

    the car will stay upright if left parked for upto a week, but drive it and it will drop only the rear right side..... going to go with elimination i guess, move the left bellow to the right side and...
  16. 2013 Audi A6 Allroad self levelling suspension error

    Hello Guys,

    I have the above car that has me stumped! it keeps dropping the rear right side suspension when driven for approximately 25 minutes and also the red suspension error on the dash

    so...
  17. Replies
    16
    Views
    9,495

    Hello @dana . We have loads of these DQ500...

    Hello @dana . We have loads of these DQ500 gearboxes equipped on the 2011 onwards Tiguans. What would you need to help you guys ?? Let me know and ill get on it.
  18. Replies
    2
    Views
    435

    2008 Passat 3c ABS Coding help

    Hi guys,

    I have 2008 Passa that had the parking brake module replaced in another workshop and require the ABS Coding to complete the
    repairs. Autoscan is below, thanks in advance

    ...
  19. Replies
    2
    Views
    1,146

    The code with the module not coded error was...

    The code with the module not coded error was initially 0000014
  20. Replies
    2
    Views
    1,146

    2007 Q7 Level Control coding.

    Hello guys,

    can someone please verify the coding for the above Q7 level control module. the front end is sitting low and I cant callibrate it as it initially had a module not coded error.
    I tried...
  21. Audi Q5 0B5 Gearbox pressure too high error

    hey guys,

    so I have the above audi that keeps logging the below fault to do with pressure too high on clutch 2. ive tried doing a basic setting procedure as listed elsewhere on this forum

    and...
  22. Replies
    4
    Views
    1,176

    I tried a new Genuine switch but got the same...

    I tried a new Genuine switch but got the same result... also checked the brake pressure sensor signal and it seems plausible with 0Bar pressure brake not depressed and a gradual rise when depressed...
  23. Replies
    3
    Views
    1,998

    the G247 fault was caused by us when checking the...

    the G247 fault was caused by us when checking the socket was plugged in properly. no faults are logged otherwise........
  24. 1,4tsi Golf 5 Fans running through out

    hello,

    we have a grey import 1.4Tsi (dual charge) that had the jumpers reversed and ended up killing the ECU.

    the owner had a used replacement installed and coded/unlocked (not dealer) after...
  25. Replies
    3
    Views
    1,998

    2007 3.0Tdi Touareg No start

    hello,

    I have a touareg here that came from another workshopi after body work and will not start.

    the statement from the owner is that i had been involved in a minor accident to the front end...
Results 1 to 25 of 138
Page 1 of 6 1 2 3 4