Search:

Type: Posts; User: downtime

Page 1 of 20 1 2 3 4

Search: Search took 0.09 seconds.

  1. Small update to the calibration device. I...

    Small update to the calibration device.

    I decided to update my calibration device to be more exact match to the OEM device.

    All you need is a tangential fridge fan and adjustable tripod to...
  2. Do you get any errors in vcds autoscan? My...

    Do you get any errors in vcds autoscan?

    My understanding is that the compressor clutch is not activated if the compressor run in basic setting is not done. AC does not work.

    What exactly was...
  3. Not possible I'm afraid. It's always with a ding...

    Not possible I'm afraid. It's always with a ding :(



    This is only with TJA and even then only when ACC is active. The activation speed is not settable through coding or adaptation.
  4. Ignition on, engine off? That means Basic...

    Ignition on, engine off? That means Basic settings carried out, so I don't quite get the error.

    And seems that you also need to do the compressor run in basic setting. That needs engine to be...
  5. So aircon yells for basic settings. Go to hvac...

    So aircon yells for basic settings. Go to hvac module -> basic settings and run the flap motor basic settings from there.
  6. Spacewalker has Touran? For that the 556 camera...

    Spacewalker has Touran? For that the 556 camera works. It can use Tiguan parameters if nothing else is found. Pretty much the same height and angle.

    Thinking that should I try to replace the rear...
  7. Replies
    54
    Views
    3,291

    Or 27mm? But I just suck at reading the measure :D

    Or 27mm? But I just suck at reading the measure :D
  8. I didn't find it either, maybe that's why I did...

    I didn't find it either, maybe that's why I did not do it :)

    I used ODIS for regen cycle and if I remember correctly I tried to do dpf sensor adaptation from the basic settings there and it stated...
  9. I swapped my DPF sensor as well last october and...

    I swapped my DPF sensor as well last october and although the instructions say that you need to adapt the new sensor, I didn't. I did run a forced regen though but no adaptation was done.

    I've...
  10. Replies
    54
    Views
    3,291

    That would be my guess as well. If there's a...

    That would be my guess as well. If there's a ghost detected in park assist mode, it will probably quit the assist.
  11. Your gateway installation list at least is...

    Your gateway installation list at least is completely messed up. You have stuff enabled that are not existing in your car. I would first clean up the installation list by unticking all the...
  12. Lane departure warning is coded in instruments....

    Lane departure warning is coded in instruments. Uncheck that and the error is gone.

    For the ABS, now not 100% sure but the error might be due to incorrect engine type coding in ABS. Should be...
  13. Replies
    54
    Views
    3,291

    Yes, the rears were original sensors but for...

    Yes, the rears were original sensors but for China market.

    Maybe use sensor holders from another car model? If you find with similar angle?
  14. Replies
    54
    Views
    3,291

    I've had really bad experiences with Chinese PLA...

    I've had really bad experiences with Chinese PLA sensors. In our Leon the Chinese sensors didn't work at all. They constantly gave an error and dropped out from the system.
    Those could be your issue...
  15. Replies
    54
    Views
    3,291

    My guess is that your side sensors have incorrect...

    My guess is that your side sensors have incorrect holder. Usually the PLA sensor holders are angled so that the sensor is pointing to the side. Now without angled holder your sensors are pointing a...
  16. On long coding ABS you need to modify the ABS...

    On long coding ABS you need to modify the ABS coding so it understands the new sensors. I don't see why short coding ABS would be any different. Try first without coding, if it flags an ABS error...
  17. Replies
    2
    Views
    159

    Depends on the reverse camera version. Can you...

    Depends on the reverse camera version. Can you please post a full autoscan from your car?
  18. Replies
    54
    Views
    3,291

    I don't think it matters. I did park assist...

    I don't think it matters. I did park assist retrofit to 2007 Golf Plus which never had even front parking sensors from factory. There were no guidance on which orientation the sensors need to be....
  19. Replies
    7
    Views
    128

    What exactly did you change?

    What exactly did you change?
  20. Replies
    7
    Views
    128

    Go to 4B module -> basic settings, start the...

    Go to 4B module -> basic settings, start the headlight basic settinc and the choose aknowledge basic setting.

    Headlight range 55 or multifunction 4B triggers basic setting requirement everytime...
  21. Replies
    135
    Views
    7,596

    Looks like that is the case :...

    Looks like that is the case : https://www.youtube.com/watch?v=enTLlsxQM3o
  22. Replies
    135
    Views
    7,596

    That would explain the request out of range error...

    That would explain the request out of range error :)
  23. Replies
    135
    Views
    7,596

    One more try with the virtual cockpit coding,...

    One more try with the virtual cockpit coding, there were some other things missing as well like stopping distance reduction, lane maintenance assist bap etc.


    ...
  24. Did you finish the system test? Maybe that is now...

    Did you finish the system test? Maybe that is now preventing the steering assist basic setting
  25. Replies
    135
    Views
    7,596

    ^ what do you mean? Dashboard does not have...

    ^ what do you mean? Dashboard does not have parameters.

    From what car the VC is from?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4