Search:

Type: Posts; User: morski

Page 1 of 4 1 2 3 4

Search: Search took 0.08 seconds.

  1. Replies
    4
    Views
    153

    Looks like you mechanic has not done the job...

    Looks like you mechanic has not done the job properly.The steering angle sensor needs calibrating for a start. You will need VCDS or a similar diagnostic tool to recalibrate the sensor. Not difficult...
  2. Thread: Battery

    by morski
    Replies
    10
    Views
    285

    A new battery might not be super cheap but they...

    A new battery might not be super cheap but they can be the magic pill to huge host of issues.
  3. Where's the first part of your scan? Is the...

    Where's the first part of your scan?

    Is the new module the exact same part number as your old one? Is the coding the same?
    Normally a new ecu would be a virgin unit with no coding at all but...
  4. Replies
    4
    Views
    141

    You can get the engine to start... Once you have...

    You can get the engine to start... Once you have have the power gauge on left showing ready press the accelerator to the floor and the engine will start. but as Uwe has stated the battery disconnect...
  5. Thread: Audi a3 8v

    by morski
    Replies
    8
    Views
    321

    Sorry...my sarcasm comes across as a bit strong...

    Sorry...my sarcasm comes across as a bit strong at times.. :D
  6. Thread: Audi a3 8v

    by morski
    Replies
    8
    Views
    321

    Yes, Audi sell bypass resistors. Just ask the...

    Yes, Audi sell bypass resistors. Just ask the parts department which airbag you want to bypass and they will supply you one. Steering airbag resistors are always in stock.
  7. Whats your transmission code?

    Whats your transmission code?
  8. Thread: Audi a3 8v

    by morski
    Replies
    8
    Views
    321

    Wow, you should put the car back together first,...

    Wow, you should put the car back together first, clear fault codes and then see what you have left.
    Airbag issue needs new bonnet actuators. These blow after a frontal impact and raise the bonnet...
  9. Replies
    16
    Views
    584

    Probably due to a mismatch of VIN' no's in the...

    Probably due to a mismatch of VIN' no's in the modules. You would need to go online and recode the modules with the correct VIn so they are all the same.
  10. Replies
    12
    Views
    7,036

    any particular vendor you recommend in china. pm...

    any particular vendor you recommend in china. pm if rules apply for posting here. thanks
  11. There is also another fuse apart from the 40A...

    There is also another fuse apart from the 40A one. Smaller one in the same rear fuse block. Really need to have a good look through the full wiring diagrams
  12. Check the main power cables that go to the...

    Check the main power cables that go to the compressor. The thick cables just by the compressor tend to burn out when there has been a leak due to excess current. There might be a few strands of cable...
  13. If its a 2014 My then you should be able to...

    If its a 2014 My then you should be able to access the engineering menu in the mmi and change the setting of the 'joker' button to something else. This should then change the menu in the mmi. I think
  14. I use this.....

    I use this.. https://www.ringautomotive.com/en/product/RSCPR50

    Works great and doesn't cost an arm and a leg
  15. anyone have any input??

    anyone have any input??
  16. I think you really need to relook at the fuses...

    I think you really need to relook at the fuses and the location of other fuses for the power steering. Audi have done a good job of putting fuses in all sorts of locations. There is some high power...
  17. Replies
    28
    Views
    2,896

    So what have you done with the mileage? Using the...

    So what have you done with the mileage? Using the one on the S3 shown or...??
  18. Replies
    6
    Views
    892

    Had a similar fault when i retrofiited the a6...

    Had a similar fault when i retrofiited the a6 power tailgate. VCDS would not let me do the basic settings. Used odis offline and worked.
  19. Replies
    5
    Views
    319

    I would plan to get all the modules, ie gateway,...

    I would plan to get all the modules, ie gateway, engine ecu, clocks, bcm, etc that are form the donor car along with full wiring looms and refit it to the recipient vehicle. All of them will be coded...
  20. 'Incorrect basic setting' is the norm fault...

    'Incorrect basic setting' is the norm fault display when the SRI has been done incorrectly as mentioned above.
  21. Always take the customers story with a pinch of...

    Always take the customers story with a pinch of salt.
  22. Being under warranty why didnt the main dealer...

    Being under warranty why didnt the main dealer replace the damaged fuel tank? Must have been an impact or something. How severe was it? The fuel pump/filter sits inside the tank so have you reused...
  23. 2012 A6 4G side assist and Engine timer fault

    Been fitting a new sub the other day and had the battery terminal on and off whilst doing it. So thought i'd clear some fault codes and am stuck with the 'P150 engine off timer performance' code...
  24. Replies
    48
    Views
    3,525

    There is no component protection on these modules...

    There is no component protection on these modules and work with out calibration when retrofiited to another car. Mine did
  25. Replies
    15
    Views
    631

    Research shows its a common fault on the VAG...

    Research shows its a common fault on the VAG range, mainly the Golfs. New thermostat and or water pump solves the issues.
Results 1 to 25 of 100
Page 1 of 4 1 2 3 4