Search:

Type: Posts; User: BinsuJiro

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Replies
    22
    Views
    1,288

    Uwe, thanks for sending the diagram.

    Uwe, thanks for sending the diagram.
  2. Replies
    22
    Views
    1,288

    Thank you, Shaun. I will try that, and also...

    Thank you, Shaun. I will try that, and also inspect the connector in the A4 based on Uwe's image showing the pin locations.
  3. Replies
    22
    Views
    1,288

    I tried the HEX-NET on the other Audi, a 2015 A4...

    I tried the HEX-NET on the other Audi, a 2015 A4 Quattro Prestige, and the HEX-NET did read the CAN bus. If I'm trouble shooting the cars OBD-II bus at pins 6 and 14, how would I be able to do that...
  4. Replies
    22
    Views
    1,288

    Dear Uwe, Well, I got side tracked and didn't...

    Dear Uwe,

    Well, I got side tracked and didn't get a chance to try the HEX-NET on the other Audi, a 2015 A4 Quattro Prestige until two days ago. The HEX-NET did read the CAN bus. It did take a bit...
  5. Replies
    22
    Views
    1,288

    Hi Uwe, I have one outside now; Ill try to run...

    Hi Uwe, I have one outside now; Ill try to run the diagnostic on that one now. Back in a few.
  6. Replies
    22
    Views
    1,288

    Dear Uwe, please see the scan data I sent to...

    Dear Uwe, please see the scan data I sent to Shaun. BTW the CAN reads as not ready, but Audi seems to be able to read the 01 through 07 addresses, and on some occasions I can read those addresses. As...
  7. Replies
    22
    Views
    1,288

    Shaun, here is the entire scan. Addresses 01...

    Shaun, here is the entire scan. Addresses 01 through 07 did not read. The self test read:

    APP Id (1) CodeBlock V0.4437 API V4 FW version: 0.254. Dataset: 60000055

    K1: OK, K2: OK, CAN Not...
  8. Replies
    22
    Views
    1,288

    OK, Shaun, I'll go out and run a complete...

    OK, Shaun, I'll go out and run a complete autoscan, and I will try the Options -> Self Test for K1 and K2. BTW, this car does not have any aftermarket equipment installed anywhere. I'll be back soon.
  9. Replies
    22
    Views
    1,288

    Shaun, thanks for your advise; please see my...

    Shaun, thanks for your advise; please see my reply to Uwe. Best, Binsu
  10. Replies
    22
    Views
    1,288

    Dear Uwe, I tried that and the HEX-NET makes...

    Dear Uwe, I tried that and the HEX-NET makes three attempts to initiate the K-line and will not load any address from 01 through 07. OBD-II data is unavailable. However, the Check Engine Light [CEL]...
  11. Replies
    22
    Views
    1,288

    I have been unable to even access the OBD-II...

    I have been unable to even access the OBD-II fault codes, and all of the other addresses output results. One anomaly I noticed is that some engine data appeared for a split second when I first...
  12. Replies
    22
    Views
    1,288

    Yes, I'm using VCDS mobile, and I will try to...

    Yes, I'm using VCDS mobile, and I will try to select. But, I still cannot access the OBD-II data to find out what codes are being thrown.

    Best, V
  13. Replies
    22
    Views
    1,288

    HEX-NET will to read engine addresses

    I have a 2008 2.0T A4 Quattro which showed a check engine light two days ago. The A4 seems to be running well, but I cannot gain access to the OBD-II fault codes, and when I run a diagnostic none of...
  14. Replies
    10
    Views
    772

    Shaun, I'm pleased to say that the update was...

    Shaun, I'm pleased to say that the update was finally successful. I pressed the red button on the HEX-NET and reset the mode. I also ran the registration tab. Everything then downloaded and installed...
  15. Replies
    10
    Views
    772

    OK! I am trying what you suggested. At first run...

    OK! I am trying what you suggested. At first run of the Interface Config Application I got 5 error messages:
    1. Can't create registration key 'HKCU\Software\VCIConfig' (error 5: access is denied); ...
  16. Replies
    10
    Views
    772

    Great, Shaun! I'll try that now. Thank you!

    Great, Shaun! I'll try that now. Thank you!
  17. Replies
    10
    Views
    772

    PetroDave thanks for the reply! But, regarding...

    PetroDave thanks for the reply! But, regarding BootCamp, I have always replaced the stock drives in my MacBook Pros with 1TB drives which I partition. This has always save all of my data during past...
  18. Replies
    10
    Views
    772

    Shaun, thanks for the reply! I was using a WiFi...

    Shaun, thanks for the reply! I was using a WiFi connection just a few feet from the WiFi router using my iPhone. I did dig out an old ThinkPad today that barely operates and does not have a...
  19. Replies
    10
    Views
    772

    HEX-NET Stalls During Update

    I have been trying to complete the latest firmwear/data set update, but the process stalls at 43% with an ETA of ~30 during verification of the 28667 KB downloaded file out of the total 29184 KB to...
  20. BTW I also tried to access address 01 directly,...

    BTW I also tried to access address 01 directly, but could not, so I have no method to identify the cause of the check engine light.
  21. Hi Uwe, I do have a PC to use, and will try that...

    Hi Uwe, I do have a PC to use, and will try that later today when the car is back here. I tried to do an Auto Scan, but the VCDS-Mobile app could not identify the vehicle model, so I ran a selected...
  22. I'm sorry that was a partial answer. I'm using...

    I'm sorry that was a partial answer. I'm using VCDS-Mobile on my iPhone with access to the Internet via my local network.
  23. I'm connecting via my local WIFI network.

    I'm connecting via my local WIFI network.
  24. HEX-NET Dual-K plus CAN WiFi Interface not reading addresses 01-05

    A check engine light was activated on my wife's 2008 A4 Quattro Sedan, however my HEX–NET [recently updated to the latest software/firmware] will not read OBD II addresses in the ) in the 01 – 05...
  25. Good evening Jack! I conveyed your...

    Good evening Jack!

    I conveyed your appreciation to my wife. It was indeed an enjoyable afternoon.

    I got the compression tester, and this evening before it got too dark outside I did a first...
Results 1 to 25 of 51
Page 1 of 3 1 2 3