Search:

Type: Posts; User: myounus

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. If this is now sorted can you post an updated...

    If this is now sorted can you post an updated scan for reference. Thanks
  2. STG13 goes out of alignment as the alignment was...

    STG13 goes out of alignment as the alignment was aborted part way through. The calibration ODIS does at the dealers calibrates both the J428 and R242 together. 4 wheel alignment has also got be...
  3. If you’ve missed some codings out then of course...

    If you’ve missed some codings out then of course ODIS will fail as it’s designed to calibrate to a ‘stock’ install. You can get a third party device to work, however that’s another story.
    Set the...
  4. Replies
    2
    Views
    119

    The fault could be due to wiring that may have...

    The fault could be due to wiring that may have come loose. Check your connections.
  5. Good point. I’ve had to invert wires when...

    Good point. I’ve had to invert wires when installing Ali express LHD equipment which is why I thought it might be wiring. We don’t know how it’s wired so can’t really say yet, but good point about...
  6. The wires are likely to be the wrong way. I can’t...

    The wires are likely to be the wrong way. I can’t see the different hardware/software likely causing a mirror to inverse. Left/right wiring is likely to be the issue. What diagram did you use??
  7. You can’t code it out legally, just put up with...

    You can’t code it out legally, just put up with the error on the dash
  8. Replies
    8
    Views
    274

    Ah ok. Try your last original BCM

    Ah ok. Try your last original BCM
  9. Replies
    2
    Views
    107

    What problem are you getting? Did you replace...

    What problem are you getting? Did you replace with a reconditioned gearbox?
  10. You can pick them up in almost any scrap yard,...

    You can pick them up in almost any scrap yard, they have loads of them lying around in written off cars. That'll be cheaper than getting replacements from the dealers. However, if none are open due...
  11. Replies
    8
    Views
    274

    Have you got a scan from your original setup to...

    Have you got a scan from your original setup to compare? Please post, thanks.
  12. Try them all. I’d try reset zero calibration...

    Try them all. I’d try reset zero calibration first.
  13. It seems that the active steering/steering angle...

    It seems that the active steering/steering angle sensor need re-calibrating. Try this page from the wiki:
    http://wiki.ross-tech.com/wiki/index.php/Audi_A5_(8T)_Steering_Wheel_Electronics
    ...
  14. Clear the fault codes.

    Clear the fault codes.
  15. The ACC is a safety feature, why would you want...

    The ACC is a safety feature, why would you want to code it out? It’s not expensive to fix, the biggest cost is recalibration 200 at the dealers and you can’t escape it!
  16. In the buckle clip, however, clear all your other...

    In the buckle clip, however, clear all your other faults first!
  17. Thread: Oxygen Sensor

    by myounus
    Replies
    4
    Views
    142

    Try a regeneration drive, 4th gear on the...

    Try a regeneration drive, 4th gear on the motorway for 30-40 mins to clear out the DPF. If the fault returns it could be the DPF pressure sensor or the oxygen sensor.
  18. My first port of call would be to test the wires...

    My first port of call would be to test the wires around the steering.
    Secondly, I'd replace the steering angle sensor and faulty speed sensor. Perform basic settings and calibrations.
    If that...
  19. Thread: Oxygen Sensor

    by myounus
    Replies
    4
    Views
    142

    Hi When you replaced the EGR did you run...

    Hi

    When you replaced the EGR did you run through all the basic settings?
    What problem are you having with car? Are there any lights on the dash? I would've expected an error to show up in 01...
  20. mmm I would firstly try clearing all of the...

    mmm I would firstly try clearing all of the faults. Then taking the car for a drive and see what fault return. I suspect that when changing the alternator a few wires may have been stretched/pulled...
  21. Replies
    9
    Views
    382

    The only way I can see is to remove the...

    The only way I can see is to remove the diagnostics for the bulbs. As Uwe stated there is no way to specify a different bulb type.

    Try the following for the rears:
    You will need to login to...
  22. Replies
    9
    Views
    382

    If it's a transporter T3 then I don't think it...

    If it's a transporter T3 then I don't think it will be possible without using load resisters.
  23. Replies
    2
    Views
    225

    If you would kindly provide some info on your...

    If you would kindly provide some info on your vehicle and an autoscan we may be able to help.
  24. Replies
    3
    Views
    636

    Hi Please kindly post an autoscan. Please...

    Hi

    Please kindly post an autoscan. Please check the logs for your previous coding and revert it back.
  25. Replies
    5
    Views
    295

    Defective means it needs replacing.

    Defective means it needs replacing.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4