Hi,
Looking for some help with disabling the exhaust flaps on a new S3. When I untick Bit 2 (Exhaust Flaps Installed) in the Long Coding Helper and try to save I get the following error: "Coding rejected Error 31: Request out of range". This coding works on 2018 and older models.
I’ve tried both v18.9.1 and beta v19.1 with a HEX-V2 interface. I can save other coding changes to this module successfully.
Thanks
Peter
Looking for some help with disabling the exhaust flaps on a new S3. When I untick Bit 2 (Exhaust Flaps Installed) in the Long Coding Helper and try to save I get the following error: "Coding rejected Error 31: Request out of range". This coding works on 2018 and older models.
I’ve tried both v18.9.1 and beta v19.1 with a HEX-V2 interface. I can save other coding changes to this module successfully.
Thanks
Peter