• Section Widget

  • Categories Widget (Show All)

  • Recent Articles

  • Slijo

    There is no available content written by Slijo
  • Recent Article Comments Widget

  • Recent Blog Posts

  • Recent Forum Posts

    PetrolDave

    How to replace a BCM? (2005 T5)

    It's very probably that module #09 will have more than 1 pin that should have power (always on and ignition switched), you really need to visit the erWin

    PetrolDave Today, 03:20 AM Go to last post
    ai_Ingo

    VW caddy 2016 DPF regeneration

    Just as Patrol Dave wrote, clean or replace the DPF. Then the DPF must be reset with VCDS. But this can only happen if it has either been cleaned or replaced.

    ai_Ingo Today, 03:18 AM Go to last post
    PetrolDave

    A8 DRL tweak

    The ignition should ALWAYS be on when doing a scan as many modules are only fully powered when the ignition is on.

    If you are worried about

    PetrolDave Today, 03:17 AM Go to last post
    gokarty

    [New Project Setup] How to find out/decode wiring information and pin-outs

    Don,

    Firstly, thank you very much for your input!

    However, I'm not sure if I understand correctly, even if the LED DRLs are

    gokarty Today, 02:55 AM Go to last post
    D. Antonov

    A8 DRL tweak

    Thanks for the swift response! Do you know, by any chance, how much time it will take for the full Scan? Because I heard somewhere that this type of scan

    D. Antonov Today, 02:47 AM Go to last post