Hello from England.
My first support post so bear with me a little.
I'm trying to adapt (if its even necessary?) a new G450 sensor on a 2.0 CR TDi CAHA by following the instructions shown on Ross-Tech page HERE. However there the selection for [Coding-2] is completly greyed out when connected to Engine controller.
Not sure whether I need to post a full scan or not so just let me know and I'll upload.
My first support post so bear with me a little.
I'm trying to adapt (if its even necessary?) a new G450 sensor on a 2.0 CR TDi CAHA by following the instructions shown on Ross-Tech page HERE. However there the selection for [Coding-2] is completly greyed out when connected to Engine controller.
Not sure whether I need to post a full scan or not so just let me know and I'll upload.