So, I successfully replaced the defroster flap motor and now the HVAC is working normally again, blowing air to the windshield as supposed.
But I can't get rid of the following fault:
1 Fault Found:
329989 - Motor for Defroster Flap
B1090 54 [009] - Missing Calibration / Basic Setting
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 1
Reset counter: 134
Mileage: 280577 km
Date: 2021.01.24
Time: 13:03:34
Voltage terminal 30: 14.4 V
Outside temperature: 10.0 °C
Inside temperature: 19.0 °C
Defroster flap: actual value: 82
Defroster flap: actual value: 34.0 %
Defrost door - Specified value: 83
As I stated above, the motor is now working as supposed and everything is fine.
I've done the adapt door end stops procedure with success couple of times but the fault code comes back immediately.
Any ideas?
But I can't get rid of the following fault:
1 Fault Found:
329989 - Motor for Defroster Flap
B1090 54 [009] - Missing Calibration / Basic Setting
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 1
Reset counter: 134
Mileage: 280577 km
Date: 2021.01.24
Time: 13:03:34
Voltage terminal 30: 14.4 V
Outside temperature: 10.0 °C
Inside temperature: 19.0 °C
Defroster flap: actual value: 82
Defroster flap: actual value: 34.0 %
Defrost door - Specified value: 83
As I stated above, the motor is now working as supposed and everything is fine.
I've done the adapt door end stops procedure with success couple of times but the fault code comes back immediately.
Any ideas?