3Q0980654 adaption channels for initial calibration

[Ewald]

Hi all,

the 3Q0980654 camera has been installed in many vehicles. It can be calibrated without special tools by changing the following adaptation channels:

IDE10924-MAS02479-Initiale Kalibrierung: Ergebnis-Gierwinkel,0.243 °,8 
IDE10924-MAS05286-Initiale Kalibrierung: Ergebnis-Wankwinkel,-0.265 °,8 
IDE10924-MAS05287-Initiale Kalibrierung: Ergebnis-Nickwinkel,0.986 °,8 
IDE10924-MAS10678-Initiale Kalibrierung: Ergebnis-Kamerahöhe,1399 mm,8

Hight to be measured by laser and angles can be taken out of measurement channels.

How to do that with VCDS? The login is 89687. VCDS fails when I want to safe a new value.
VCP has no problems to change the above mentioned channels in Engineering Mode after login.

 

[downtime]

I think that is the problem. You need to be able to change to engineering mode to input those values and VCDS is not able to do it afaik.

 

[Uwe]

You need to be able to change to engineering mode to input those values and VCDS is not able to do it afaik.

What if it could, and you just had to know how?

-Uwe-

 

[downtime]

Interested. What would be the magic needed for that?

 

[Ewald]

What if it could, and you just had to know how?

Maybe you want to let us know to do this job with VCDS?

 

[AINils]

There are 2 ways, use custom label with change command or just some magic which is secret by Uwe ;-)

 

[Ewald]

Custom label is clear. What do you mean with "change command"?