MQB CH/LH without light sensor

   #1  

Vagcomlimburg

Verified VCDS User
Verified
Joined
Dec 23, 2020
Messages
4
Reaction score
0
Location
The Netherlands
VCDS Serial number
C?ID=406527
Hi,

how do you guys do this?

add interior light as light function on lightchannel for leaving home?
And driverdoor manual for coming home? We dont want to use the flash highbeam handle, just open door..

Thanks in advance
 
   #2  

TBAx

Verified VCDS User
Verified
Joined
Dec 3, 2016
Messages
686
Reaction score
591
Location
Germany
VCDS Serial number
C?ID=287144
As you already wrote:
Add the light function "Interior light" to the desired Leuchte as "Lichtfunktion" in BCM adaptions. Check also, if the Dimming Direction and Dimming value fits your needs.
There are no settings to configure. The emulated CH/LH will always kick of when the Interior light is triggered by the BCM.
 
   #3  

DV52

Verified VCDS User
Verified
Joined
May 16, 2014
Messages
4,023
Reaction score
4,518
Location
Melbourne, Australia
VCDS Serial number
C?ID=194404
And driverdoor manual for coming home? We dont want to use the flash highbeam handle, just open door..

@Vagcomlimburg: Hi, To add to @TBAx response, and specifically in regard to your other question above, the BCM normally requires the adaptation channel ENG141656-ENG116601-Außenlicht_uebergreifend-Coming Home Verbaustatus to be set to automatic . However, this won't work on cars that don't have an AUTO position on the LDS (which your car won't have because no light-sensor). So - not possible, alas.

Don
 
   #4  

Vagcomlimburg

Verified VCDS User
Verified
Joined
Dec 23, 2020
Messages
4
Reaction score
0
Location
The Netherlands
VCDS Serial number
C?ID=406527
@Vagcomlimburg: Hi, To add to @TBAx response, and specifically in regard to your other question above, the BCM normally requires the adaptation channel ENG141656-ENG116601-Außenlicht_uebergreifend-Coming Home Verbaustatus to be set to automatic . However, this won't work on cars that don't have an AUTO position on the LDS (which your car won't have because no light-sensor). So - not possible, alas.

Don

hi

thanks
Yes that was what i was thinking

can i put it on manuel and put on ignition instead of driver dopr
To let it work with the hendle on the steering wheel
 
   #5  

DV52

Verified VCDS User
Verified
Joined
May 16, 2014
Messages
4,023
Reaction score
4,518
Location
Melbourne, Australia
VCDS Serial number
C?ID=194404
@Vagcomlimburg : hmm.......... unless someone else here says to the contrary, again - alas NO. The method that @TBAx describes isn't CH/LH; it's a surrogate for these functions only. In truth, both CH and LH have very specific requirements to operate successfully - so there's not much flexibility for deviation.

Don
 
   #6  

TBAx

Verified VCDS User
Verified
Joined
Dec 3, 2016
Messages
686
Reaction score
591
Location
Germany
VCDS Serial number
C?ID=287144
@DV52 is right. The interior light version is not a fully fledged CH/LH replacement but more like a "light" or rather "zero" variant.
 
Top