PASSAT B8 SW SIDE/LANE CHANGE ASSIST RETROFIT

[sam1754]

Finally you soldered 3 wires, right?

 

[downtime]

Can’t really tell as there’s no autoscan but if you can connect to 3C and CF modules then most likely connection is ok.

 

[jrhenrique]

I mean, I use the right wires?

 

[jrhenrique]

Finally you soldered 3 wires, right?

Yes! Use the ones on the photo!

 

[jrhenrique]

Pin de Henrique Sousa Junior em Car

9/out/2020 - Henrique Sousa Junior encontrou este Pin. Encontre (e salve!) seus próprios Pins no Pinterest.

pin.it

No coding yet! But 3C and CF active

 

[downtime]

Then coding. Register the 3C and CF to gateway and start coding them in.

 

[jrhenrique]

Coding done! All working great! No error codes!
Thank you all!

Pin by Henrique Sousa Junior on Car | Vehicle gauge, Vehicles, Gauges

Oct 13, 2020 - This Pin was discovered by Henrique Sousa Junior. Discover (and save!) your own Pins on Pinterest

pin.it

 

[sam1754]

Finally works for me too!
But I had an issue with open circuit lamps DTC. I had to connect to ground one controller at a time and DTC gone away.

 

[sam1754]

Side assist also retrofitted on my Passat Sedan successfully. But I had to flash both controllers and load correct dataset this time. The seller sent me radars from an Audi A3...

 

[sam1754]

Now I would like to learn more about how dynaimc calibration is performed??? I know it's about an angle which needs to become narrow but how... Which controllers'data are used???

 

[karldietmann]

Did anyone manage to DIY a calibration tool?