2014 A6, Lane Assist Slave Radar Replaced, Basic Settings/Adaptations Error Remains

[downtime]

^What do you mean?

And what are the static calibration values you got? Most importantly what was the offset of the radars it measured in static cal? I found out that if they're over 1 degree off the dynamic calibration will struggle.

 

[Totopirate]

Hello, so after checking I am at: - J770 = -0.72 - J769 = -1.05

I did the calibration well, but it always ends in failure ... I can't understand.

 

[PetrolDave]

And what are the static calibration values you got? Most importantly what was the offset of the radars it measured in static cal? I found out that if they're over 1 degree off the dynamic calibration will struggle.

Hello, so after checking I am at: - J770 = -0.72 - J769 = -1.05

I did the calibration well, but it always ends in failure ... I can't understand.

Looks like J769 needs to be adjusted and the static calibration repeated?

 

[Totopirate]

Looks like J769 needs to be adjusted and the static calibration repeated?

I am wearing within the tolerance of -4.99 to 4.99

 

[PetrolDave]

I found out that if they're over 1 degree off the dynamic calibration will struggle.

I am wearing within the tolerance of -4.99 to 4.99

You may be within the published tolerance of -4.99 to 4.99 but downtime's experience (which I quoted above) tells him that if it is over 1 degree then dynamic calibration will struggle.

 

[Totopirate]

OK, thanks.

The I am much lower than 1 °. the side assist does not work, I did about 20KM. I also have the transversal assistant which does not work. I think the dynamic calibration is not complete?

 

[downtime]

Check from the meas values of side assist module that what it says about dynamic calibration? Kms driven and status is visible there.

If the dynamic cal fails that is usually due not good enough static calibration. But you’re values are very good so that somehow does not seem like an option either.

 

[Totopirate]

for the moment I have no errors, but the side assist does not work .... I will do several km to see. if there are defaults.

 

[Totopirate]

well i just got an error message in the car ... cross traffic assistant malfunction ... i can't understand ...