DCC (Dynamic Chassis Control) Reset/Calibration

[Muzza80]

Hi all,
I've a quick question.

Does anyone know if my VCDS is capable of running the reset/calibration of DCC (Dynamic Chassis Control) on a 2018 vehicle?

I'm fitting a set of lowering springs to my own car and have been advised that after fitting the DCC should be reset with the vehicle raised and then lowered so the control unit knows the maximum extension and the new lower start point of the dampers?


Address 14: Susp. Elect. (J250) Labels: 5Q0-907-376.clb
Part No SW: 5Q0 907 376 B HW: 5Q0 907 376 A
Component: DAEMPFUNGS-SG H17 0121
Serial number: 18111741350839
ASAM Dataset: EV_DRCONTITEMIC 001019
ROD: EV_DRCONTITEMIC_VW27.rod
VCID: 3829D60502D832378A8-806C

No fault code found.


Is it a simple process?

Any advice greatly appreciated!

 

[MasterTommy]

Would be interested to know this as well...

 

[Uwe]

I would think it can be done on that module, but I doubt anyone has developed a procedure for it.

If anyone goes to play, I would suggest NOT trying either of these Basic Settings:
IDE06680 - Reset to as-delivered condition of control module manufacturer
IDE06681 - Restore vehicle-specific data

-Uwe-