Search results

  1. V

    Skoda Rapid DSG - Gear selector blinking no communication with TCM

    Finally, the problem was solved. The old mechatronics was good; there was an issue with the wiring routing under the wiper. The CAN high and low lines for the selector were damaged. This caused the TCU communication errors to be brought up in the scans. The car is up and running now.
  2. V

    Skoda Rapid DSG - Gear selector blinking no communication with TCM

    Here is the full scan Saturday,07,December,2024,11:55:03:42575 VCDS -- Windows Based VAG/VAS Emulator Running on Windows 11 arm64(arm64 CPU)(Parallels) VCDS Version 24.7.0.0 (arm64) HEX-V2 CB: 0.4643.4 Data version: 20240715 DS356.3 www.Ross-Tech.com VIN: TMBBULNA4FG021112 License Plate...
  3. V

    Skoda Rapid DSG - Gear selector blinking no communication with TCM

    I checked the switch in the selector, and it is working as expected. When I check for faults in VCDs, I get a new error: the engine is starting, but the gear lever refuses to disengage, and the indicators are blinking. There's also a coil icon on the instrument cluster, which is also blinking...
  4. V

    Skoda Rapid DSG - Gear selector blinking no communication with TCM

    Thanks. for OAM F319 will be the switch to check here right?
  5. V

    Skoda Rapid DSG - Gear selector blinking no communication with TCM

    I have successfully replaced the mechatronics unit and carried out basic settings using ODIS. Now there is only one error left: the car starts but refuses to move the gear selector, and here is the error that im getting on both VCDS and ODIS. 005940 - Starter Enable from Selector Lever Sensor...
  6. V

    Skoda Rapid DSG - Gear selector blinking no communication with TCM

    tha thanks btw in January 2021 when i had this same issue, the part number that was replaced with was 0AM927769D CONTR UNIT I assume this is the tcm module alone of the mechatronics; this will be a bit cheaper than the entire unit, right? Is this recommended or a full unit swap, which is...
  7. V

    Skoda Rapid DSG - Gear selector blinking no communication with TCM

    The car broke down while running, and the gear selectors blinked rapidly. Now, the car won't move in any gears. Attached is the full scan report. I tried changing the gear selector bush on the gearbox, reconnected it, and did a visual inspection of the mechatronics wiring harness. When I try to...
Back
Top