Search results

  1. R

    Audi TTS Headlmp Module coding

    Yea but now I've changed one module back, so now they are all original those fault codes have gone but now has thrown up a completely different code so what module is faulty, there are three modules.
  2. R

    Audi TTS Headlmp Module coding

    Thursday,05,December,2024,12:24:39:18619 VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64 VCDS Version: 24.7.1.0 (x64) HEX-V2 CB: 0.4643.5 Data version: 20240919 DS356.3 www.Ross-Tech.com VIN: TRUZZZFV3H1022347 License Plate: BP7GYD Mileage: Repair Order: E3...
  3. R

    Audi TTS Headlmp Module coding

    Hi All I have put the original Module back into the headlamp today and it now shows as Low Voltage all the other warnings, the no signal and incorrect code has gone, I presume the used Module must be faulty, can you tell from the scan which Module has the low voltage. would a soft reset cure this?
  4. R

    Audi TTS Headlmp Module coding

    Thanks, I'll put the original module back in and see what it says.
  5. R

    Audi TTS Headlmp Module coding

    Hi Thanks yes i can see that, the question is, is this like this because there is no code 000000?
  6. R

    Audi TTS Headlmp Module coding

    Hi Normally I would agree that it could be a wiring issue ,but there is no damage to the wiring, just as important when the original module was in both the dipped and main beam worked and the only MIL warning said low voltage, which i presume was because it was full of water I dismantled it and...
  7. R

    Audi TTS Headlmp Module coding

    Any ideas on why there is no signal? The 3 left Light codes are E01400 1of the right ligjt codes is the same E01400 the other 2 of the right light codes are E01800 and 000000 Can you tell me are these the codes that are for the lights, can i change these, i can only presume they should be the...
  8. R

    Audi TTS Headlmp Module coding

    Hi Thanks for the swift reply when it states there is no signal could this be because the code is incorrect, as both beams worked with the original water damaged module and this fault code was not there. Dave
  9. R

    Audi TTS Headlmp Module coding

    Hi I have an Audi TTS 2017 with Zenon lights, I had to replace the right lamp due to damage, I purchased a used one with same part number, I took the 3 modues out and put them into the replacement light it all worked but a warning light came up saying Low voltage on one of the modules this one...
Back
Top