Search results

  1. R

    VW Sharan 2017 2.0tdi 184ps Fuel Rail Pressure Too High

    Apologies, that must have been done after initial clearing of P0088 fault. Mileage: 251902 Repair Order: -------------------------------------------------------------------------------- --------------------------------------------------------------------------------...
  2. R

    VW Sharan 2017 2.0tdi 184ps Fuel Rail Pressure Too High

    This is a copy of the original Auto Scan but from Notepad so could not put it in with 'Code' sorry Mileage: 405390km-251897mi Repair Order: --------------------------------------------------------------------------------...
  3. R

    VW Sharan 2017 2.0tdi 184ps Fuel Rail Pressure Too High

    Recently had vehicle returned after having Reconditioned engine fitted. Engine, Turbo, Fuel Pump (high Pressure), Reconditioned Injectors, EGR Valves, Glow Plugs and DPF Cleaned. Vehicle ran ok initially, while taking it for it's annual test (here in the UK) dropped into Limp Mode, Glow Plug...
  4. R

    Blind Spot Mirror Sensor

    I haven't done a scan for this as I don't particularly see it as an error and as such won't show up on any scan, it's simply been set to 'off' in the module and was looking for somebody to point me in the right direction. Obviously you feel it is an 'issue' with me not posting a scan, so with...
  5. R

    Car dead would not start.

    Had this happen to one of my Superb 2.0Tdi Technology. Would be fine then suddenly go to start and nothing! Adaptive Cruise Control and Horn would not work. Before I ran a diagnostic, did a quick search on the internet and things pointed to a 'dying battery' I have a boost pack that I carry with...
  6. R

    Resolved Error Message on Update

    Sorry, should have updated. Went back to upload again and it all worked, not sure why the error came up?
  7. R

    Blind Spot Mirror Sensor

    Just recently added 2 Superb Estates to my fleet. One of them, 2019 2.0Tdi Technology the Blind Spot Sensor is not 'permanently' set to on so need to go into the Car Settings every time the car is started to tick the box and switch it on. Anybody know the sequence to switch it on through VCDS...
  8. R

    Resolved Error Message on Update

    Tried to update today and got error message: Exception thrown in destructor (f:\dd\vctools\vc7libs\ship\atlmfc\src\mfc\filetxt.cpp;67) Any suggestions??
  9. R

    Seat Belt Warning

    Hi, sorry don't have one at the moment. The vehicle belongs to a friend of mine. I found the channel, IDE03867 and wondered if it was possible? I will catch up with him in the next few days and get a scan of the vehicle and post it
  10. R

    Seat Belt Warning

    Have done a search on the forum and cannot find a thread about this. Is it possible to code out the seat belt warning on Seat Alhambra 2019 using VCDS?
  11. R

    Just another VAG nut with anti-social coding complex

    Hi, thanks for the input and info which is pretty comprehensive. Firstly, with the exception of the Superb which I purchased recently, all my other vehicles are manual. Admittedly, running a small taxi company certain vehicles only do short local work but the rest do get a regular blast up the...
  12. R

    Just another VAG nut with anti-social coding complex

    Hi VRS2, has your DPF problems remained 'cured'? I have had a similar problem for sometime and like you had a garage undertake the 'chemical clean' but still having issues. They replaced the EGR valve recently which, to be honest, has helped but not resolved the problem. I have also tried the...
  13. R

    Engine Vibration at Idle and Juddering Pulling Away

    It's a bit rough at idle but once you move up the rev range and increase speed it runs ok, given that it does have 151,000 on the clock. Had the vehicle running at idle and by pushing the clutch pedal up & down you can hear the note of the noise change and the rattle. So at the moment will...
  14. R

    Engine Vibration at Idle and Juddering Pulling Away

    Hi, my VW Sharan 2017Y has developed an engine vibration at idle and juddering on pulling away? Undertook a VCDS scan and apart from the TPMS errors that were down to a slow puncture which has been repaired the only other faults are 18826 Coolant Pump for Intercooler and 03789 Terminial 75 Limp...
  15. R

    Exhaust Temperature Sensor Readings.

    Waiting for the car to go into the garage to have a replacement EGR valve fitted and a check on the DPF as it very quickly 'blocks' and requires a very regular service regeneration and always appears to be attempting a passive regeneration, rise in tick over speed to approx 1000 rpm and fans...
  16. R

    DPF Regeneration.

    So, the saga continues. Still have issues but with no fault codes showing, no EML and not going into limp mode keep trying different things to cure the problem. I don't think the DPF is blocked despite the DPF light coming on eventually after trying something different. Having run an exhaust...
  17. R

    DPF Regeneration.

    Hi, I am still having DPF issues with my 2012 Octavia II 2.0 CR but think I may have narrowed it down now. I believe when the new turbo was fitted along with a Throttle Body, Lambda Sensor and DPF Pressure Sensor the new DPF Pressure Sensor was not adapted as is required and it still thinks it...
  18. R

    DPF Regeneration.

    **UPDATE**UPDATE Though I would update the forum on where I am at with my DPF issues! These came about after having a replacement Turbo & Throttle Body fitted. All was well initially but after a couple of days things started to go wrong. Took it back to the garage, they did another re-generation...
  19. R

    Powerfold Mirror Programming on Seat Alhambra

    I want to reprogramme my powerfold mirrors to fold in when locking & out when unlocking the vehicle.Found a couple of videos on YouTube on a Golf and Audi, one of which was by entering the security code and the other by long coding? Not too sure on attempting long coding at the moment but the...
  20. R

    2019 Seat Alhambra 2 fault codes 0852 & 03789

    I have a Seat Alhambra 2019 that has 19,000 miles on the clock. I was looking to alter the settings on the power fold mirrors for them to operate on locking and starting the engine but that is another story? However, before doing anything, I ran a full Auto Scan as attached. As something of a...
Back
Top