Search results

I did the update after I switched to beta and now everything works. Using the interface is also way faster than It was before :) tyvm!

haha no worries about beeing offended :)

Seems I was just confused with the names of all the tools.. I updated trough VCIConfig yesterday but I did access it from vagcom tool ^^ I deleted rod data/cache from phone and it says now that "updated rod data needed" and I guess that's expected. It updated rod yesterday when i did it.. I...

Is something deleted or am I just stupid not getting the joke? :P

I did try this after reading some other threads but it didn't change anything. Will follow the advice above with doing it from VCIConfig and see if it helps. Thanks

I tried both on my home network and in the car far away from houses/wifi signals with the same result. Wifi coverage seems to be good also as I can walk pretty far away from the car and still have contact with the interface. I updated with the vagcom software trough the option menu but I can...

I have my interface connected to my phones AP so it has internet. Trying to update the ASAM it starts off showing 20min remaining then suddenly 4min but progress bar is at 40% and 1kb all the time. After the 4min it jumped back to 10min but progress bar is not moving. The interface has 2 green...

VW touareg V10 2003, VW Multivan 2.5 2004 and Audi Q7 Etron 2017. The Etron has the gateway installation so it's not a problem like the two others. I will try to make a custom auto-scan entry so I don't have to browse far down in the drop-down list. I didn't know about this feature. Can I do...

I would like to suggest to have car profiles/favorites that can be selected on the first screen when opening vagcom. When selecting a car it can show a custom control module screen containing only the controls modules that are in my car and when going in auto scan the proper model can be...

perfect! I did this and before starting it again I did the 50sec reset, powerdown and powerup again and now the message is gone.

I Just received my new interface and registered it but it shows the same error as this. I tried following your instructions above @Uwe but it didn't solve it for me. Also tried connecting with a computer I never accessed it on before like the user above and it shows the same error on that unit...

Did you get access with one of the new ones or do y ou have the old and it failed for you aswell?

Have you seen the info given in page 20 of SSP 663 on the 4M chassis? It describes the axle load calibration but it doesn't describe it after sensor swap only with module swap. Maybe it's not needed to clear it before calibrating the level? Hope I'm allowed to link this. Found it on a Google...

No ODIS backup plan here :D I guess that If this fails I will have to go to the dealer for a calibration anyways. Do I risk the module by testing this?

thanks. I'll check if I can upgrade mine first then and give this a go.

I have a I do have a vehicle hoist so I could test this. Does this require the newest interface from rosstech? I have a hex+can interface and it won't connect with the chassis control module. My ODBEleven interface connects to it with CAN:UDS at 500kbps baud. I've sent a request for a update in...