Search results

  1. JMR

    How to replace access start authorization switch

    First of all.. check to see if steeeing column is locked or unlocked. It seems to me that you have a ESCL problem perhaps . Connect your VCDS then try to connect to address 05 . If you cant , try to wake up the car by switching the hazards on or the cars headlamps a few times while trying to...
  2. JMR

    2001 Jetta TDI ALH

    You ll see a loom of wires coming around the engine on that side , strip the wires in that area
  3. JMR

    2001 Jetta TDI ALH

    You have shortcircuited wires for sure , i remember fixing something like this , on the right side of the car ( your left when you look at the engine )
  4. JMR

    Skoda Yeti 2010 ABS coding lost (MK60EC1)

    Try this one ( shown as the most likely to match your car ) as computed by a 3rd party , followed by the basic settings 913F400E092401FC890C02E99019804A350000
  5. JMR

    Resolved No start, no crank

    10 v is kinda low aint it ?
  6. JMR

    Resolved No start, no crank

    Identify the starter relay(s) , take them out , pry them open from their housing , put them back and squeeze then by hand. If the starter cranks....check ground and voltage . If all good , start digging wires
  7. JMR

    Crank, no start, fuel pressure issues

    Could it be that the engine is just "flooded" ? I ve sold one of my Mazda 6 2.3i recently and the mechanic that i ve sold it to changed the headgasket and did some work on the engine block. He had the head checked and repaired. After mounting everything back , he started the car , then he didn t...
  8. JMR

    Crank, no start, fuel pressure issues

    so is your lpfp pushing fuel as it should constantly ?
  9. JMR

    Particle Regeneration failure Audi A6 Allroad 2018

    you should verify your egr unit ( clean it /replace it )
  10. JMR

    Crank, no start, fuel pressure issues

    well...if your fuel is good , the timing is ok, i'd try to tow it in 3 rd gear for a bit .When you have a bit of speed, with ignition on and in the 3rd gear, lift your foot off the clutch . Have you tried to spray a bit of brake cleaner in the intake to see if it catches ?
  11. JMR

    Crank, no start, fuel pressure issues

    i've yet to see one ecu taken out by this..but i couldn't be ever surprised
  12. JMR

    Crank, no start, fuel pressure issues

    please check your fuel, just the other day i had bmw 2.2 petrol ( older one, year 2000 ) , put a bad combination of fuel ( petrol mixed with water ) and had same problem. Take a bit of the fuel , few drops , put it on the ground an try to lit it up. If it's pure petrol it will catch fire, if...
  13. JMR

    EPB and ABS Module will not read (2009 Passat)

    Post autoscan
  14. JMR

    Ukraine

    I wasn t aware that America was at war with Russia... For all intents and purposes i thought that it was between Russia and Ukraine :eek: :cool:
  15. JMR

    EPB and ABS Module will not read (2009 Passat)

    You need to do steering stop limit by holding the steeering wheel all the way to the left for 10 seconds , then all the way to the right for 10 seconds. Then verify the motor for right parking brake ( fuse , plug or motor ). Only after the right motor works youd be able to do basic settings , by...
  16. JMR

    2011 VW Polo P0171 Nightmare...

    P0171 it s a nightmare to solve...
  17. JMR

    EPB and ABS Module will not read (2009 Passat)

    You should not have all them errors if parking brake motors are good. I see something about the parking brake switch...no voltage to the parking brake motors...hmm..have you cleared and rescaned ?
  18. JMR

    2011 VW Polo P0171 Nightmare...

    Try a different fuel filter ...some are so fine the gas wont flow right through them , say..try a Bosch , it s fairly cheap. Also , check the evap hoses , does it smell like gas in the engine compartment ? Could be many causes , also a loose intake could create this problem. Spray some starting...
  19. JMR

    Ukraine

    Been a while huh ? Still going ....
  20. JMR

    2015 Audi Q7 P2146 Supply Voltage for Fuel Injector Group A or a bad ECM?

    Probably a defective injector or bad wiring
Back
Top