Search results

AFAIK ecm determines this by checking coolant temp in comparison between thermostat temp sensor and other coolant temp sensors in the system.

Rough calculation based on some options in the vehicle and experience with these cars.

Try this it may or may not work. Part No SW: 8W0 820 043 T HW: 8W0 820 043 T Component: Klima Zone 3 H55 0210 Coding: 140904095544440D02000100880000000000000000000000000000000000

Pump is timed to the engine AFAIK. So if timing is off, fuel pressure will be higher than normal. Given the fact that this is the same engine as the 2.0T that's known for timing chain issues among other things It would not surprise me.

In order to marry remotes you need other tools like ODIS or maybe autel will do it. I never tried I always use ODIS for such jobs on newer vehicles.

Are we sure there is no debris possibly blocking the flow of coolant?

Correct but I will say this is the tach needle is moving I would say spark is good. However on a bug depending on model year it may not have a tach. So correct check and verify spark, fuel and compression and or timing. marcop300 If you think its fuel related spray some brake clean into the...

Need to marry remotes to BCM. After checking tire pressures did you reset the tpms as needed using wiper stalk or buttons on steering wheel?

ABS coding stored in abs module is correct per vin. Please check tire pressures.

I would recheck physical timing.

please swap cam adjustment solenoids from bank to bank and see if the fault follows. This is a common fault when those solenoids fail or the screen inside them falls apart jamming them up.

Please can phase adaption values. Also when cranking does the tach needle move?

Lets no guess and make the necessary checks as mentioned.

+/- 10% tops on those older vehicles. Newer vehicles are up to 15% or more IIRC.

26000011863CAFE0240048C300003D0D0F9C9388A2090221000008000000030100000030000000

How about a autoscan with a vin.

Prior logs show this as being the correct coding prior to reflash. After reflash the coding does indeed change. Data source: MAGIC Hardware part number: 1K0907379AE Part number: 1K0907379AE Hardware version number: H35 Software version number: 0106 Production date: Coding: 14 42...

I can provide coding for a small fee.pm me if your in a rush.

Check all connections at the rack. Test all wires. If all checks out it needs a rack. EPS function is part of the rack IIRC.

Correct my mistake Hardware part number is a AE. However coding is still incorrect per vin. Data source: MAGIC Hardware part number: 1K0907379AE Part number: 1K0907379CE Hardware version number: H35 Software version number: 0120 Production date: Coding...