Search results

Morning all. I am in the process of retrofitting lane assist to my TRoc. It appears I was sent the wrong wiring loom and now need to modify the current one. I am after the part number for the connector that plugs into the camera unit(3Q0980654) Then I can hopefully figure out what the pins are...

I searched everywhere for a better set of instructions/ wiring diagram and was unable to find anything. So decided to first check one of the fuse outlets was permanent 12V and the other was a switched. After confirming that, I ran temporary jumpers to switch them. After that it appears to be...

Unlikely but I’ll check. The instructions only mentioned which wire goes to which fuse reciprocal. It doesn’t mention which is permanent and which is ignition. I triple checked before connecting them as they not the easiest to insert into such a tight place from behind. The error also pops up...

Thank Thank you for that. I have unset [17]Byte11, bit5 and it cleared one of the issues. Just left with one now. Getting so close to solving. The fault that remains is - No Communication with Towing System Control Module (J345). I am able to clear it, but will return after I restart the car...

I have managed to get a bit of time to try go through all the options again. and still showing these fault codes, even after clearing them. Everything appears to be working fine. - Trailer lights all correct and no faults on dash - Reverse parking sensors disabled when towbar electrics...

All the modules I am having issues with have no descriptions at all. Im away for a few days but will check again when back

I have cleared these faults several times, but they keep coming back.

I have recently installed a Westfalia removable tow bar with the Trail-Tec CAN module. That all went easy enough. I coded the following after install and then cleared all faults. All have cleared except for a few. Any idea what I may have missed or messed up. These are the steps I took so far...