I think i will measure resistance at B383 B390 where they join up, as the modules are on the same Route. i could also at the OBD connection.Just another Test:
- What do you measure of resistance between CAN-H and CAN-L when ignition is off (wait 60 Seconds after off).
- On my 2013 T5 with everythig possible retrofitted on engine can, i get 59 Ohm
- In My Table Setup with 01 03 09 15 i get 63 Ohm
with all modules connected,
I think the issue is on the Can - H side as no fuction on 6 of my Breakout box only Can - L and later do a test with reconnect the Eco 01 & leave ABS removed and see what info is then shown,