Just to add to this, my A6 C7 is FL MY2018 has had a reversing camera installed with integrated module and have the same CAN fault message:
Yes the camera works however knowing it isn't quite as Audi intended is pushing me to understand & resolve this fault, OCD kicking in!
[5f]
ENG12229-ENG117712-Car_Function_List_BAP_Gen2-VPS_0x0B = activated
ENG122229-ENG117713-Car_Function_List_BAP_Gen2-VPS_0x0B_msg_bus = Terminal 15
erWIN diagram 116/2 shows power from [SB ST1] which is a switched fuse and diagram 116/3 shows CAN Extended high/low into [J533] under the rear seat. However my camera has been connected into the rear boot panel CAN breakout which I don't think is correct based on what erWIN wiring diagram 116/3 indicates.
It is obviously communicating on CAN but perhaps not CAN Extended?
1. Would rewiring into J553 CAN Extended (under rear seat) resolve the fault as the system would send the correct message?
2. and would I need to change the above msg_bus to CAN Extended?
Any guidance would be very much appreciated.
Thanks in advance!
Code:
Address 19: CAN Gateway (J533) Labels:* None
Part No SW: 4G8 907 468 K HW: 4G8 907 468
Component: J533--Gateway H15 0110
Revision: -------- Serial number: 00000002944682
Coding: C0CD074418
Shop #: WSC 02391 785 00200
ASAM Dataset: EV_GatewPkoUDS 002011
ROD: EV_GatewPkoUDS_002_AU57.rod
VCID: 408450DDDB25F88442-8014
1 Fault Found:
5807 - Rear View Camera System Control Module
U104C 00 [008] - No communication
Intermittent - Confirmed - Tested Since Memory Clear
Yes the camera works however knowing it isn't quite as Audi intended is pushing me to understand & resolve this fault, OCD kicking in!
Code:
Address 6C: Back-up Cam. (J772) Labels:| 4S0-980-556.clb
Part No SW: 4S0 980 556 A HW: 4M0 980 556 A
Component: RVC Compact H15 0201
Coding: 0275000102002003000040
Shop #: WSC 79104 790 00000
ASAM Dataset: EV_CamSysRVRVCPANAAU57X 002003
ROD: EV_CamSysRVRVCPANAAU57X_002.rod
VCID: 39723D39B8FFA94C05-806C
No fault code found.
[5f]
ENG12229-ENG117712-Car_Function_List_BAP_Gen2-VPS_0x0B = activated
ENG122229-ENG117713-Car_Function_List_BAP_Gen2-VPS_0x0B_msg_bus = Terminal 15
erWIN diagram 116/2 shows power from [SB ST1] which is a switched fuse and diagram 116/3 shows CAN Extended high/low into [J533] under the rear seat. However my camera has been connected into the rear boot panel CAN breakout which I don't think is correct based on what erWIN wiring diagram 116/3 indicates.
It is obviously communicating on CAN but perhaps not CAN Extended?
1. Would rewiring into J553 CAN Extended (under rear seat) resolve the fault as the system would send the correct message?
2. and would I need to change the above msg_bus to CAN Extended?
Any guidance would be very much appreciated.
Thanks in advance!
Last edited by a moderator: