Recent content by vastechnics

Have done a lot already

In 6c

True. I did not seen this sorry indeed need to be manual

try and report then everybody here knows also

Try this: - Park steer assist put coding back to original. So make back up camera coding off. - In 5F turn off byte 19 bit 1. Make this codings: VPS to activated VPS bus to Terminal 15 ENG122227-ENG117496-Car_Function_Adaptations_Gen2-menu_display_pdc,aktiviert ,60...

Hello iichel, i can confirm that it has to do with VCDS. Have now got maybe 5-6 cars display same. No coding available. So i think but since update.

Guys. This problem is related to the car. From factory 4K pdc and camera dont work. Need proper coding. That is problem! when you have camera work optical parking will no display. Only camera and beeping

if feed is permanent will be no problem check again

Maybe proper codee?

has to do with SW of the BCM, must be at least 0575 for LED to work. you have 0541, will never work

I can provide coding but high beams won't work. For high beams need connect full AFS. High beams work by Canbus. byte 11 bit 1 -> 0 byte 14 bit 4 -> 1 byte 17 bit 2 -.> 1 byte 18 -> 74 byte 19 -> 08 byte 21 bit 1 -> 0 byte 24 -> E4 byte 29 -> bit 3 This should do the trick

where did you connect the supply for the turn signals?

Ok lets say it doesnt has G85 ok leave that a side. Then I dont understand why the 0x44 can not be reached and still saying no comm with G85. So that confuses me a bit i have tried 3 different pumps all same. I can not imagine that 3 are broken.

I don't understand where the G85 is located as it is not by canbus behind steering wheel. I have tried coding 0x04 but then gateway gives fault no communication and in gateway list says also not reachable

I will look at this. Thanks. I will post when i have something. strange thing is never is something changed.