Jack_warner99

So on further software investigation i discovered in the ABS module if i read the values theres an option for "ESP Warning light" and...

I’ll give that a try. But yeah I get what you mean, just abit odd? Previous owner mentioned the vehicle had an “economic map” Is it...

Yes very interesting that it pops up in HVAC

Hi Guys, I've got a fault: 00281 - Vehicle Speed Sensor (G68) 37-10 - Faulty - Intermittent I had a quick google and it...

Good plan! I’ll order a new door lock module too as I’m almost confident that’s to contribute for the door always been registered as...

Ahhh fair. Well in which case I’ll check the loom for damage and see what I can do, if all else fails I just found one on eBay for £12...

I just get worried about dropping it or supporting it and fitting it on my own as Iv never done it 😂

Is that including unplugging the loom from the car? Would make a lot of sense to repair it with it unplugged then just running the loom...

I’ll take a look, I tried the wiggle trick and didn’t really notice any OBVIOUS difference? However I have noticed if I move the window...

If you look in Erwin, Workshop Tab - The official notes are that Soldering is forbidden !! A soldered joint is brittle !! Especially...

Try it, why not. :thumbs: If it doesn't work, it's really not difficult to remove the door.

Ok thanks mate ill have a look, may just strip back and add more wire, if not ill go down the scrappy and see if i can find a new door...

I’ll check this. Thankyou!

Ah balls. No way I can solder it without taking the door off?

Lamp works fine when I turn it on manually. I did notice when I opened the passenger door once the light came on for a second then...