rvralph64

Will do, thanks.

Ok, I will do that. It might a few days until I get back. Thanks

Hi Dr Sheldon, I don't have a scope or is that a function in VCDS?

Hi Uwe, Check this out. I went out for a test drive and again it at times refused to accelerate when I stomped on the pedal. It is a...

I just filled it up with 87 octane, regular from a reputable gas station,no cheap stuff but that did cross my mind to try Premium grade...

Hi Uwe, I cleared the fault code and ran the auto scan 3 more times, twice while driving and once again when parked while engine still...

I noticed the data got garbled. Hopefully this works better. Friday 16 May 2025...

[Deleted -- illegible]

Ok. I will do that after I finish changing the transmission oil. It really needed it, it's very black!

#7 confirms G66 #2 knock sensor low intermittent. #3 is clean no fault codes. The test drive results during power loss. #1 0.0 #2 2.3...

I agree, I want to know why it's doing that. I use a cheap obdII scanner as I drive around to see when all the smog sensors are ready...

Is P0332 really a problem or just a warning? I don't get CEL on the dash and I would really like to resolve the isssue rather than...

Ok, that makes sense. Thanks for explaining that. On a related note, if I am getting voltage readings, is there a reason why cylinders 1...

Hello Uwe, I will check for the timing delay but just curious why or better yet how is it able to determine voltage output for each...

I am hoping that someone knows the answer to this riddle. Knock Sensor 2 Signal too low- intemittent. I visibly checked the cables...