Recent content by JPE

Sorted it out The problem was the 13 pin adaptor was not working properly once I changed this all apereas ok

Hi i have an Audi 2015 Q3 and have installed a used Swivelling Towbar and have connected the wiring from the back of car to the module. i have tried to program the car but have no lights at the tow bar, the parking sensors do not deactivate however the LED at the cable pull in the boot works and...

These are the options available and the stalk has the correct buttons but the long code will not save with Bit2-3 or bit 6-7 changes.

The full scan is below I believe the other faults are because of the fault with the switch. 01-Engine -- Status: OK 0000 02-Auto Trans -- Status: OK 0000 03-ABS Brakes -- Status: OK 0000 04-Steering Angle -- Status: OK 0000 05-Acc/Start Auth. -- Status: OK 0000 08-Auto HVAC -- Status...

I have a 2016 A7 and I am retrofitting Active Lane Assist + Traffic sign recognition, I have Led Matrix lights and adaptive headlights so have the camera in the windscreen . I installed the loom from KUFATEC and a used 8E-Image Processing unit and stalk I kept my original steering slip ring...