You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
A
Update.
The fault was found to be damaged 12V supply cable in loom from inside car to JX1.
They eventually found an abnormal volt drop...
-
A
Agreed, but I'd like to make sure this is the case by measuring the propshaft RPM which should be zero if the 4wd clutch is disengaged.
-
A
Sure but these is no sense in posting an Auto-Scan without any fault codes.
-
A
Worth mentioning is also that there seem to be a repair kit (0B0598082) available for the rear axle coupling fork
-
A
Hi.
I suspect that my differential is going bad as I have a drone/humming sound which is noticable on soomth/high grip surfaces.
The...
-
A
Hi.
Yes for me the faultcodes were all caused by the broken can-bus wire. As I also changed the drive inverter I was unable to start...
-
Loading…
-
Loading…
Like.
Update. The fault was found to be damaged 12V supply cable in loom from inside car to JX1. They eventually found an abnormal volt drop...