Robert-VW's latest activity
-
Robert-VW reacted to Uwe's post in the thread Use of cable with laptop connected to mains with
Like.
A computer connected to the mains should never be a problem, no matter how crappy the mains power supply is -- provided you don't also... -
Robert-VW reacted to VWT6's post in the thread How to tell if headlight has CAN bus module? with Like.
Check the wiring diagram - chances are that you'll find an isolation relay on the CANbus branch to front radar - even on VW.
-
The sensor connects directly to ECU so not related to any relay. Well, as an owner of HEX-V2 you could verify the sensor. Possibly...
-
I would fix the above first.
-
Please plot also "Soot Mass Measured" along the "Calculated". I would expect the jump happens when the "Measured" reaches the DPF regen...
-
Robert-VW reacted to dnoermann's post in the thread 2016 Passat NMS having issues with ACC retrofit. with Like.
Sorry yes, the Bosch guys start counting Bit with 1 in their Documentation :)
-
Robert-VW reacted to dnoermann's post in the thread 2016 Passat NMS having issues with ACC retrofit. with Like.
Yap, i am very shure i reported this "Generic" Error years ago :) For ECU´s which support the long Coding with that Byte 5 having 2...
-
Robert-VW reacted to Uwe's post in the thread 2016 Passat NMS having issues with ACC retrofit. with Like.
No, not the module. Coding info still comes from VCDS, either from the ASAM data supplied by VAG that VCDS has as .ROD files, or from...
-
Robert-VW reacted to dnoermann's post in the thread 2016 Passat NMS having issues with ACC retrofit. with Like.
All the Faults the ACC is showing are Timeout Faults in CAN Communication. So you have either - Cabling issue in CAN Cables to Radar -...
-
Robert-VW reacted to siLc's post in the thread Problems with RVC module and can gateway module in 2014 VW CC with Like.
With appropriate tools (or people with access to appropriate tools), you could have software updated AN to BL and saved the cost of the...
-
I don't have a tested code to offer but the 4H0 series Component: TopView Back-up Cam. modules accept SA code 20103 when 22351 is...
-
Perhaps you could post engine's blockmap data: VCDS > Applications > Controller channel map > [Controller 01, Measuring values, CSV...
-
Will just post back results on this car, The problem was that the other garage had not been careful with the injectors when having them...
-
Robert-VW reacted to Eric's post in the thread VW Crafter 2011 support for Advanced Measuring Values? with Like.
Should be covered now, we have 076-906-022-G in the redirect file which will load 076-906-022-CEC.CLB . Has measuring block infos for...
-
Robert-VW reacted to iichel's post in the thread Caddy MK4 ABS module long code (MK100ESC) with Like.
Yep I guess that would be good. INterestingly, the car is PR UG1: Hill start assist UG1 Hill start assist