Recent content by VAGMAN

  1. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    Hi Martin, Interesting you should say they, the injectors seats were oval however this matched the profile of the injectors, so I didn't take much notice. I was checking to see if there was any un even wear, but didn't find anything out of the ordinary. I had removed the entire injector cam...
  2. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    The first 2 injectors were loose, seems like someone has had a play with them before. The bolts seemed they had been re-used and not torqued to the correct setting, the last 2 injectors were fitted correctly, there was no play whilst they were seated. replaced the 3 o rings and the nipple on...
  3. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    Okay, I tried using group 35 and initiated the process 4 times, you could hear the in tank fuel pump running, started the car and same issue, took about 6/7 seconds to start with similar values in the engine and camshaft speed. I have noticed that there seems to be smell of diesel in the...
  4. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    Thanks guys, just to confirm, this model doesn’t prime when the door opens, you can hear the in tank pump prime when the key is set to position one before cranking, I have repeatedly put the key to position 0 and back to position 1 about 10 times to ensure there is enough fuel pressure being...
  5. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    Having gone through the log, I notice the following: Address 08: Auto HVAC Labels: 8P0-820-043.lbl Part No SW: 8P0 820 043 M HW: 8P0 820 043 M Component: KlimavollautomatH18 0260 Revision: 314473 Serial number: 8P0820043M Shop #: WSC 06314 000 00000 VCID: 366560074124AB39AB-8062 1 Fault Found...
  6. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    There is no option for reading any relevant pressure, I've selected a few additional items but not sure if they can provide an assistance. TIA Marker TIME Group 1 - Field 0 Group 12 - Field 2 Group 16 - Field 3 Group 18 - Field 0 Group 22 - Field 2 Group 51 - Field 1 Group 51 - Field 3...
  7. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    There are a couple of errors which have been logged as I've changed the battery and not taken the car onto the road for a test. Tuesday,14,September,2021,16:57:53:25558 VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64 VCDS Version: 21.9.0.2 (x64) Data version: 20210903 DS330.0...
  8. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    Hi Uwe, I changed the glow plugs yesterday with a new set as there was a random message on each glow plug cylinder (when logged, it would always log all 4 glow plugs), since changing the glow plug that message no longer appears. I'll do the auto scan and check if fuel pressure is available...
  9. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    Added a new battery, Varta 800A 80Ah, read 12.60 volts before starting but the same issue, 7-8 seconds to start.
  10. V

    2006 Audi A3 2.0 TDI DSG BKD Cold start

    Hi, I'm looking for some guidance/direction on an issue I have with a 2006 Audi A3 2.0 TDI DSG BKD. if the car is left for more than 3/4 hours, it's very difficult to start - it eventually starts. I've added a non-return fuel valve to try and prevent fuel running back but this hasn't helped...
  11. V

    2006 Audi A3 2.0 TDI DSG (BKD) - Limp mode p-0299

    Update, I had a smoke test done to ensure I didn’t miss anything out, that came back all good. In the end, it turned out the turbo vanes were seized and the arm was free, moving effortlessly when the actuator rod was removed, this was confirmed after the turbo was taken off. thanks for...
  12. V

    2006 Audi A3 2.0 TDI DSG (BKD) - Limp mode p-0299

    Hi ED30R, it has 2 components, one is the EGR valve which also has vacuum actuator and the throttle body which has a flap that opens and closes, the vacuum actuator on the EGR valve was tested and it held 40 psi vacuum using a manual handheld gauge, would 40 psi represent actual driving...
  13. V

    2006 Audi A3 2.0 TDI DSG (BKD) - Limp mode p-0299

    Hi, I’ve been unsuccessful in determining the level of boost in the inlet manifold side, does anyone have a guide or instructions including what equipment would be required? Another question, is there anyway of knowing if my car has a DPF? I can’t see any DPF lights on startup. TIA
  14. V

    2006 Audi A3 2.0 TDI DSG (BKD) - Limp mode p-0299

    Thank you, I’ll give it a go and see what I get.
  15. V

    2006 Audi A3 2.0 TDI DSG (BKD) - Limp mode p-0299

    Hi Uwe, Thanks for the feedback, I've got a pressure gauge however, where would I need to hook this up to in order to get the reading? sorry for asking details but my knowledge is limited. TIA
Top