Recent content by fredgilb

  1. F

    Can not ready

    And yet when I access CAN from main menu it's there and reading. Is this different from the "Test" CAN?
  2. F

    Can not ready

    2001 beetle 1.8
  3. F

    Can not ready

    Is this a problem? everything seems to work.
  4. F

    Starts then stops

    The ECU's (2) that I used both had Immo disabled. Is it possible that they are not actually "fully" disabled?
  5. F

    Starts then stops

    here's a log of cranking no start. Curious that there is a injection time. https://docs.google.com/spreadsheets/d/1EFymYMTzVmmUsEYKi4jqV-jUfOtk5XpRyBouT1NMqhY/edit?usp=sharing
  6. F

    Starts then stops

    #191 GOES TO CLUSTER https://1drv.ms/u/s!AqsFK_xVnOIWhBnLiGjlJ_wi6NkZ?e=chaBCJ
  7. F

    Starts then stops

    The high side V. is always there. Running or cranking after motor stops.
  8. F

    Starts then stops

    Looks like low side triggered? https://photos.app.goo.gl/97V4mu64FuhuirpB6
  9. F

    Starts then stops

    The really curious thing is, only if it sits for about 30 - 45 min. will it start for a few seconds.
  10. F

    Starts then stops

    Yes, I'm still at it! I got two ECU's with imobilizer delete from the same outfit. VCDS affirms there is no Immo. 2001 Beetle 5 spd. ECU 06A 906 032 FD ME7.5 Here's where it stands. New fuel filter Cam timing ok Sounds fine when its running. Spark is always...
  11. F

    VW JETTA 2.0 TSI MANIFOLD ERROR

    I can't help it if I'm lucky! Problem just went away on it's own. This car sat around for almost 2 years, probably things got a little sticky?
  12. F

    Starts then stops

    There is something fundamental wrong. Question; does the timing for the injectors come from the same source as ignition? What does the camshaft signal do that the flywheel sensor doesn't? Immo is definitely ECU removed. (Check adap. #91) Spark is always there, injector pulse is not. Won't run on...
  13. F

    Starts then stops

    Replaced the ecu. The original had a GIAC chip. Requested an ECU w. no Immo. VCDS does not read an IMMO present. Starts for 2 sec. Question, does a bad cluster or Immo coil still have the ability cause this?
  14. F

    Starts then stops

    Wednesday,07,April,2021,12:34:27:34163 VCDS Version: Release 21.3.0 (x64) Running on Windows 10 x64 www.Ross-Tech.com Address 25: Immobilizer Labels: None Control Module Part Number: Bitte Adress Component and/or Version: e 17 eingeben Software...
  15. F

    Starts then stops

    2001 beetle 18.T 5 valve. Died on the road. No codes Fuel system = good VCDS see's rpm while cranking. Does this clear the G28? Mass air also reads. Diode test light on injector pulses while engine almost starts then stops blinking. Spark is always present. Curious, is that a period of time...
Top