Gremling

So I Finally had the car repaired at a VW dealership as the local mechanic backed away from doing the repair. It was a faulty...

This is why all 3 thing need to be verified if you ask me. If no rpm on dash usually no spark is present. As mentioned previously all 3...

Updated info, VCDS This scan was performed after TB and a few sensors wad disconnected, but also include a scan with engine running...

First scan in end of last year, after deleting the first cam/cank mismatch code Monday,28,November,2022,19:15:34:27784 VCDS -- Windows...

Yes, it is :-) Somewhere in this forum You'll find this: But this might help in the mean time Engine - > Advanced Measuring Block ID...

Regards Gremling

Just curious if you drove the vehicle with a flashing CEL for 45minutes? How was the wiring checked? what is the resistance on the...

What was the CKP voltage measured at ECU? Disconnect CKP, disconnect corresponding plug at ECU, use a multimeter, set to resistance...

Time to backprobe crank sensor at sensor and at ECU, scope time, jiihaa. Your low rpm, any chance you are miss interpeting one of the...

I would assume if no RPM while cranking on dash that it needs a crank position sensor or there is an issue with wiring for that sensor...

200 RPMS when cranking is too low should be showing 400rpms roughly. Something does not add up, If you have spark, fuel and correct...

Agree with EuroX, low rpm. Just to get things sorted, step by step. Crank, no start X Fuel present X Rpm shown in cluster and Vcds X...

Yep: https://forums.ross-tech.com/index.php?threads/35782/#post-301121 -Uwe-

Set points are relative to the calibration height, not fixed values. As for bleed/fill procedures, the erWIN directions will work fine...

What does VCDS show for engine speed or RPM'S? Where from and what brand RPM sensor? Camshaft adaptation intake bank 1? 110 compression...