Hello all,
I am in the process of adding aftermarket amps to my 2019 Jetta GLI with beats audio. I am using NAV-TV Zen-V to send optical back to a DSP.
My problem is the factory amp under the seat was not in fact MOST bus - it used speaker wire from the glovebox down the factory amp - then out to the speakers. I currently can not connect to the car using my Hex V2 - I have no k1/k2 power when I test the connection. I am also getting errors/chimes popping up for a few different circuits ex) electronic parking brake fault/ stability control/ assist issues etc etc..
The factory amp has a can hi/lo wire going to it and so I think the instructions that exist for the golf mk7 may not apply to this vehicle...
Any tips/help/direction would be greatly appreciated
I am in the process of adding aftermarket amps to my 2019 Jetta GLI with beats audio. I am using NAV-TV Zen-V to send optical back to a DSP.
My problem is the factory amp under the seat was not in fact MOST bus - it used speaker wire from the glovebox down the factory amp - then out to the speakers. I currently can not connect to the car using my Hex V2 - I have no k1/k2 power when I test the connection. I am also getting errors/chimes popping up for a few different circuits ex) electronic parking brake fault/ stability control/ assist issues etc etc..
The factory amp has a can hi/lo wire going to it and so I think the instructions that exist for the golf mk7 may not apply to this vehicle...
Any tips/help/direction would be greatly appreciated