Please ask VCP questions somewhere else.If I buy VCP unit, I'll have to pay again to obtain dataset for Side Assist and A5 camera???
-Uwe-
Please ask VCP questions somewhere else.If I buy VCP unit, I'll have to pay again to obtain dataset for Side Assist and A5 camera???
You're doing more than just "repairing" a car, no?I think Homer should be able to repair his car with only one wrench But I'm a little bit more demanding
If I understand, this plug above J533 Can Gateway pins is here to avoid multi soldering on T7/T17 which are already used for ACC and lane assist. I'm talking about the plug just at the right of "CANBUS" writted on diagram.
Am I right?
I think there's a mistake on the diagram. J533 has a T20 connector, not a T27...?
Hello, I'm enjoying lane assist retrofit and I'm willing to retrofit Side assist in addition.
I'm asking where to plug the thing above J533 on the picture below:
Where I can find this T7/T17 terminals?
Where the RC32 goes?
Thanks for the reply!
yes . i have the elsa wiring but i have isssue. i have not now to show full scan because i dont save it . i make coding to all ecuHave you wire them correct way around? Slave at driver side and master at passenger side?