mkv
New Member
Hi guys,
I'm wondering if VCDS is able to read out ZF gearbox adaptation values (specifically those boxes used in Audi's and VW, i.e. 6HP19, etc.). Like can you see these values in the measure blocks? I have a ZF transmission workbook, and it speaks about the 5 clutches (A, B, C, D, E), each with their "Fill Pressures" and "Quick Charge or Rapid Fill time".
Apparently these values are useful in diagnosing bad solenoids in the mechatronic unit. The workbook gives some tolerances which these values should be between.
Thanks
Mark
I'm wondering if VCDS is able to read out ZF gearbox adaptation values (specifically those boxes used in Audi's and VW, i.e. 6HP19, etc.). Like can you see these values in the measure blocks? I have a ZF transmission workbook, and it speaks about the 5 clutches (A, B, C, D, E), each with their "Fill Pressures" and "Quick Charge or Rapid Fill time".
Apparently these values are useful in diagnosing bad solenoids in the mechatronic unit. The workbook gives some tolerances which these values should be between.
Thanks
Mark