Assuming you have successfully connected your HEX-NET Via infrastructure mode, the following instructions will walk you through the process of creating a cloud account.
NOTE: VCDS-Mobile App for IOS currently has an issue with our cloud registration page. You will need the App for the first step. All subsequent steps will use Safari.
The entire process should take less than 5 minutes.
Prerequisites:
HEX-NET plugged into car.
HEX-NET connected to network with internet
IOS Device- iPhone or iPad (android instructions will be available soon)
VCDS-Mobile App (not needed, but makes it easier)
Step 1. Open IOS App :
The app will locate all HEX-NETs on the current network. Locate the IP number (highlighted in the picture above). Write this down. Then close out of the app.
Step 2. Open Safari.
Under the address bar, type in the IP number you wrote in the previous step. VCDS-Mobile login page will appear. The default password is: password.
Step 3. VCDS-Mobile Main Screen.
Press [Select].
Step 4. Select a module.
In this example, I click on Engine. You may select any module in this vehicle.
Step 5. Module Session.
VCDS-Mobile will connect to the module and display controller info.
Click on the Functions button.
Step 6. Cloud Functions.
Click on the Cloud Functions.
You will now be redirected to VCDS-Cloud Splash screen:
Click on the Register button to proceed.
Step 7. Registration Username/Password.
You may now fill in the Username / Password fields. Make sure there are no spaces, and the passwords match. Then click on the register button. VCDS-Cloud will now redirect to the next page/step.
Step 8. Cloud Functions Accessed.
You now have access to Cloud Functions.
FIN
NOTE: VCDS-Mobile App for IOS currently has an issue with our cloud registration page. You will need the App for the first step. All subsequent steps will use Safari.
The entire process should take less than 5 minutes.
Prerequisites:
HEX-NET plugged into car.
HEX-NET connected to network with internet
IOS Device- iPhone or iPad (android instructions will be available soon)
VCDS-Mobile App (not needed, but makes it easier)
Step 1. Open IOS App :
The app will locate all HEX-NETs on the current network. Locate the IP number (highlighted in the picture above). Write this down. Then close out of the app.
Step 2. Open Safari.
Under the address bar, type in the IP number you wrote in the previous step. VCDS-Mobile login page will appear. The default password is: password.
Step 3. VCDS-Mobile Main Screen.
Press [Select].
Step 4. Select a module.
In this example, I click on Engine. You may select any module in this vehicle.
Step 5. Module Session.
VCDS-Mobile will connect to the module and display controller info.
Click on the Functions button.
Step 6. Cloud Functions.
Click on the Cloud Functions.
You will now be redirected to VCDS-Cloud Splash screen:
Click on the Register button to proceed.
Step 7. Registration Username/Password.
You may now fill in the Username / Password fields. Make sure there are no spaces, and the passwords match. Then click on the register button. VCDS-Cloud will now redirect to the next page/step.
Step 8. Cloud Functions Accessed.
You now have access to Cloud Functions.
FIN
Last edited by a moderator: