Morning All,
I know this issue has been covered plenty of times before but im getting no where with my own problem not been able to corrrectly code my ABS moduele.
I recently had to crack a full Dash out job to replace the V71 motor, all went back together ok including the Steering Angle Sensor, after completion i had the ESP, ABS and flashing Red brake warning lamp on my instrument cluster, so i followed the Guide on Ross Techs main website to recalibrate and recide the ABS module, as you've guessed at this point no luck!!
My main problem been that after i enter my login and coding details, a warning appears in the top right corner saying 'login lost due to dropped session' which iv been led to believe means iv entered the wrong login details. I have given my login and recode details below as well as my PR codes and a full scan if anyone would be kind enough to double check me.
Iv tried this procedure several times now but i do not get the faulty Steering Angle Sensor pop up each time, only every other time?
Iv triple check the wiring in and around the sensor and brake/clutch pedals, removed and replaced the sensor but still no luck in been able to recode and recalibrate the module. Would the faulty Sensor not allow recoding?
Below are my details;
Login - 09575
Coding - 04275
[/URL][/IMG]
And the Full scan.
Any help on this issue would be massively appreciated.....its got me scratching my head now!!
Thanks in advance
I know this issue has been covered plenty of times before but im getting no where with my own problem not been able to corrrectly code my ABS moduele.
I recently had to crack a full Dash out job to replace the V71 motor, all went back together ok including the Steering Angle Sensor, after completion i had the ESP, ABS and flashing Red brake warning lamp on my instrument cluster, so i followed the Guide on Ross Techs main website to recalibrate and recide the ABS module, as you've guessed at this point no luck!!
My main problem been that after i enter my login and coding details, a warning appears in the top right corner saying 'login lost due to dropped session' which iv been led to believe means iv entered the wrong login details. I have given my login and recode details below as well as my PR codes and a full scan if anyone would be kind enough to double check me.
Iv tried this procedure several times now but i do not get the faulty Steering Angle Sensor pop up each time, only every other time?
Iv triple check the wiring in and around the sensor and brake/clutch pedals, removed and replaced the sensor but still no luck in been able to recode and recalibrate the module. Would the faulty Sensor not allow recoding?
Below are my details;
Login - 09575
Coding - 04275
And the Full scan.
Code:
Removed. Data from a clone/pirate copy of VCDS is not welcome here.
Any help on this issue would be massively appreciated.....its got me scratching my head now!!
Thanks in advance
Last edited by a moderator: